0
Can you put a 1991' Thunderbird 3.8L engine into a 1989' Mercury Cougar?
Wiki User
∙ 17y ago
Yeah, you should be able to. I had an '84 with a 3.8 L V-6.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace a front wheel bearing on a 1997 Mercury Cougar?
the front bearings on the 1989-thru-1997 ford thunderbird/mercury cougar cannot be changed, the whole front hub comes as one piece and have to be replaced as a single unit.
How do you start a 1989 mercury cougar if the engine doesn't turn and the solenoid is good?
cougar 1989 no lighting in dash instruments or speedometer. Where do I look for an open circuit. Fuses all checked good.
Is there a check engine light and a service engine soon on a 1989 Ford Thunderbird?
There is a CEL, Check Engine Light, on the 1989 Thunderbird.
How can you start a 1989 mercury cougar with a broken ignition switch?
how can you start a '89 mercury cougar with a broken ignition switch?
Where is the amplifier in a Mercury Cougar located?
Where is the radio amplifier in a 1989 mercury couger
How do you read the Oil pressure gauge on a 1989 mercury cougar?
with your eyes
Where is the dipstick hole on a 1989 Mercury Cougar?
it' on the left hand side by the exhaust
Where is the PCM on a 1989 Mercury Cougar?
The fuel PCM on a 1989 Mercury Cougar is located above the gas tank. It is on the rear fender wall on the driver's side of the vehicle. The Fuel Pressure Control Module is another way to say fuel pump.
Where is a transmission located on a 1989 Ford Thunderbird?
behind the engine in the transmission tunnel...
Is rear main oil seal 1 or 2 piece on a 1989 3.8l mercury cougar?
its one
What is the wheel bolt pattern for a 1989 Mercury Cougar?
Hi there, it is 5-108 mm. Hope this helps...
What engine is in 1989 Mercury Tracer?
1.6l
