There is probably nod difference in the integrity of these bumpers. As long as the rubber(decorative) parts match yours.
you pull it out you pull it out
You have to remove the front bumper, remove the headlight assembly. then take the fog light bulb out.
How to remove the front bumper to a 1998 Nissan Altima?
how to replace rear bumper brackets on a 2002 Nissan sentra
Bumper to bumper, 16' 0.3", (192.3")
The bumper cover changed in 1997. A '97, '98, or '99 fog light will not fit on a '95 or '96 maxima
The purge control valve is located behind the rear wheel that is on the same side as the gas tank. By simplysliding under the bumper one can view the canister and the valve.
To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.
Bumper cover or fascia.
you replace it
You must remove the bolts that connect the bumper to the frame from underneath the rear of the truck. Have someone hold the bumper so that it does not fall on you when you remove the bolts.
I'm going to re-phrase your question--how do you change the front bumper light in a 1997 Nissan Maxima. The submodel ( GLE, GXE, SE), doesn't make a difference, as all three versions have the same bumper mounted parking/turn indicators.Remove the two screws on each side of the lensThe entire lens and reflector can be pulled away from the bumperRemove the lens from the reflector assembly--don't loose the rubber gasketRemove the bulb by pushing and twisting, and then pull outReassemble by placing the lens over the reflector assembly--be sure to have the rubber gasket in the proper place. Also not the small tab on the upper side of the lens--this is installed firstPush the assembly back into the bumper and re-screw in the screws
You can purchase a new aftermarket fender for aprox. $50.00 & front bumper for $80.00. The rear bumper for aprox. $ 175.00. I recently bought these.
You must remove the front bumper!
behind the drivers side front turn signal in the bumper
its in the left and right sides of lowest slit Save on the front bumper
I have a small dent need to remove it
taking off the front bumper ... the only way to do that job like an expert.
immediate family receive the remainder of the 10/100 power train and the 5/60 bumper-bumper from the date the vehicle was purchased. Third party the remainder of the 5/60 bumper-bumper and 5/60 on the powertrain.
First remove the tailights then the trim piece on the rear body pannel(where the stanza emblem is) then you will see the bolts for the bumper hope this helps.
Aplly parking brake and raise and support on jackstandsdisconnect the negative battery cable.If equipped with airbags disconnect positive battery cable and wait 10 seconds before proceedingWorking under the vehicle,detach the screws securing the sides of the right and left front fender protectorsDetach the clips securing the front bumper protectors to the wheel wellRemove the clips and protector securing the front bumper to the hood cross bracePull the bumper assembly part way out from the vehicle and disconnect the fog lamp and side marker electrical connectors.And remove the front bumper
75-88 + shipping on www.auto-bodyparts.com
just had one replaced for around $500