It should bolt right in as the 3.4 is the same block as the 3.1 and as long as you have the wiring harness and computer your all set.
Yes
need wiring harness for a 1967 oldsmobile cutlass surpeme 330 5.4l v8 2barrel cab.
If it is a 3.1 any 1992 GM motor will work. If you are doing a motor swap from 3.1 to a 3.4 Dual Cam engine it can be done but you have to change more than the engine. The wiring harness and ECM (computer) have to be changed. Possible mounts also. If you are swapping to a newer engine (say a 1998) you might have to change the wiring and ECM.
Possibly a bad ground in the rear wiring harness somewhere.
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
Begin by removing the decorative radio retaining cover. Remove the retaining bolts. The radio will slide out. Remove the wiring harness and the antenna cable from the back of the radio.
what wires do i need to hook up to the alternator
Remove the wiring harness from the back of your 1995 Oldsmobile Cutlass blower motor. Remove the blower motor retaining bolts. Remove the fan from the front of the blower motor. Reverse the process to install your new blower motor.
No you have to disconnect the wiring under the dash.
show wire names for car stereo
Engine wiring harness is primarily used to control fuel and ignition timing. Switches, sensors and actuators are also some of the other components that are related to vehicle engine control.
Engine rotates but will not start