0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the transom located?
At the back of the boat. The transom is reinforced to accommodate the boat motor.
What is the difference between a long shaft and a short shaft outboard engine?
Boat builders manfacture their crafts' in three basic transom heights. The transom height is measured from the top of the transom, (where the engine bolts on), straight down to the keel, (bottom middle), of the boat. A 15'' transom would require a shortshaft engine. A 20" transom would need a longshaft outboard, and a boat with a 25" transom, would require a extra longshaft engine.
The transom is the?
At the back of the boat. The transom is reinforced to accommodate the boat motor.
What is the part the outboard motor connects to?
An outboard motor generally is attached either directly to the transom of the boat, or to a bracket that is attached to the transom of the boat.
Where is the transorn plate on boat?
The transom plate on a boat is located on the back of the boat. This in where the engine mounts to the boat and needs to be mounted at the correct height depending on whether the engine is a short or long shaft.
What is a transoom on a boat?
The transom on a boat is the stern on which an outboard motor can be clamped.
What is the difference between long and short shaft outboard motor?
For long shaft obm were designed to fit on high transom boat usually measured from lowest point at the bottom of the transom to the top where the obm clamp sit , about 21" in.for yamaha & 20" in. for mercury ( sorry ,for other brand you may refer to the respective manufacturer specs because I never had one).As for short shaft it were designed to fit on lower transom boat which usually measured from top to bottom around 15" to 15½".There were XL & XXL found on high power motor which fit to 25" & 30" transom respectively to cater high transom boat usually installed with 2 or more big & heavy Obm thus the load won't sank the stern as the load may excess ½ tons or more depend on engine sizes & quantity.The transom heights recommended by obm manufacturer shall be followed in order to achieve optimum performance and reliablelity of the motor as.Lonn shaft Obm has longer ``leg'' compare to the shorter shaft by 5"in. in length measure from clamp gape to the top of cavitation plate.This will allow the props and cooling water pick up were ideally submerged in the water.Long shaft obm if installed to low transom boat may compromise the handling as to turn the the boat become difficult task with tiller model and water will be drawn from the back when move due to deflection on the obm lower casing.
What is a transom plate?
A transom plate is a strengthened area used to attach an outboard motor to the rear (or transom) of a boat. see the related links below.
What is a boats transoms?
The transom is the stern end of a boat, where you mount the outboard motor on a small boat.
Will a outboard with a 20 inch shaft fit on a boat with a 20 inch transom?
Click the link.
How do you use transom in a sentence?
The "transom" is the back of a boat or ship. For a small boat, an outboard motor might be attached to the transom; for a sailing vessel, the rudder may be attached to the transom. An example sentence might be:"We were on our way back to the dock when a fish jumped over the transom and landed in the boat!"
Where on boat is the transom located?
The transom is the stern of a boat or ship. On a small boat the outboard engine is clamped to the transom.
