yes
yes when I put on lowering springs, the back seat had to be taken out
they are struts you must take out the old strut,take the springs out and put them in the new struts
Yes there is no difference in any suspension parts except the z24 will have a sway bar. so the struts and springs will fit.
No, they are different.
From my understanding, there are no springs that will fit the Mark VIII. I had to replace my air bags with springs and Front struts. it's a conversion kit. Check out strut masters. I paid to have the rear springs put on, but did the front struts myself with no help. I jacked the car up, took the olds airbags out then using a jack I lifted the struts into place tighten the three bolt on top. not to tight. This held the struts in place, while I worked dropped the wheel hub. the struts then went right in there. I tighten everything and I was good to go. I saved myself over $300 by doing it myself.
You can't. The springs around them need to be removed with a spring compressor and put back on the new struts with the spring compressor if the springs are still good. These springs are under very high tension and if you try to do it yourself you'll get a strut right through your skull! The rear shocks are easy, but for struts, take it to a professional, then it will be aligned properly too.
Take off the old ones put on the new ones
If it has lowering springs just put the stock springs in if its been body dropped and you the can't do the work yourself than leave it the way it is ,the work to un do a body drop would cost more than the cars worth It most likely has lowering springs
Yes, but you need to also change to stiffer springs.
if you are not experinced with this because the rear springs will have to be compressed to put them back on. i personaly took mine to a grage to have mine done for a better job but that is up to you on that.
I`m Not Sure How To Put This. Let Us Look At Safety First. You Can Remove Them Yourself If You Have A Very Good Set Of Jack Stands To Put The Front Of The Car On. Remove Them Then Take Them To A Shop Or Parts House That Can Press The Springs Down To Remove And Install The Struts. Then You Put Them Back On. I Would See If I Could Furnish The Struts And Have A Good Shop Install These For Me. You Probably Will Find It The Best Way To Do This. But As Stated You Can Do Some Of It Your Self. Good Luck
they are spacers that go in between the leaf spring and the axle in the rear of a car to put the springs down lower, and to raise the axle up to make the car lower to the ground.