answersLogoWhite

0


Best Answer

can the heads be remove and install in car with out removing motor

Yes. Im doing that now. Be careful with pipe at the back. They expensive to replace.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you remove the cylinder head in car 95 lt1 camaro?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a head gasket for in a car?

a seal (i.e seal) between the cylinder and the head on a car


How many cylinder head gaskets are in a 6-cylinder car?

2


Can a car run with cracked cylinder head?

No


What is meant by a valve spring compressor?

A valve spring compressor is used to remove collets in a car. The tool compresses the valve springs in the cylinder head of the car allowing the collets to be removed.


How many heads does a car has?

One, the cylinder head.


How to get to the heatercore on A 92 Camaro?

you have to remove your steering wheel and dash completely out of the car then you can access the heatercore


Why is water coming out your car manifold?

The head gasket or actual cylinder head is cracked.


Where is the temperature sensor on a 1987 camaro irocz?

below the exhaust header next to the 1st cylinder on the drivers side of the car


How do you remove the headlights and covers from a 1999 camaro?

remove the two screws mounting it to the body of the car. just slide them. they sit on a clip.


What side is 1 cylinder on 1999 camaro v6?

Cylinder 1 is on the cylinder closet to the front of the car on the driver's side. The order is 1,3,5 on the drivers side and 2,4,6 on the passenger side from front to rear.


What steps do you take to remove a 1998 Camaro clutch master cylinder?

It will be best for you to buy a Haynes Manual at a parts house or bookstore. It will give you full details and pictures. They have them that are specific to your car so you are not buying information on something you do not need.


What does the head gasket do in a car engine?

A head gasket joins that cylinder head with the cylinder block. It separated the oil and the coolant passages. If the two mix, the head gasket will "blow" soon.