0
Can you replace a pre 1996 tbi engine with a vortec long block and use your tbi intake and tbi?
Wiki User
∙ 15y ago
you can as long as you use your TBI heads if you want to use the vortec heads with TBI you will need a special intake manifold or a carb manifold with a adapter to mount your throttle body to the carb manifold heres some more info TBI heads will mount to the vortec block TBI intake manifold has 12 bolts vortec intake manifold has 8 bolts
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can you use a vortec intake on a lt1 block?
Regardless of the block, you have to use Vortec heads to use a Vortec intake.
Can you replace a vortec 350 short block with a earlier generation block?
yes ,I have change one out with a old 350 it had lot more power . I used the old heads to with vortec intake you have to slot the four bolt holes .but it will work.
Putting 1999 Vortec onto 1984 engine?
it will work I have vortec heads on a 72 400 small block, I had to get the heads reworked for the 400s water ports or steam port and a vortec type style intake will be needed
1998 Chevy Silverado coolant in engine?
If you are sure that it did not freeze and crack the block, Then the intake manifold gasket is leaking. That is a common problem with the vortec Chevy engines. You need to replace the gasket with a factory Chevy gasket from the dealer.
Will a 1999 vortec intake bolt to a 1996 throttle body injected 350 block?
NO it will not. You would need the heads off the vortec engine to make it all work. The 96 that you are talking about should be a VORTEC engine already from the factory. But you may have an early 96 and that is why it is a TBI engine. That was the year they switch to a vortec. 96 TBI no such animal,TBI OBD2 no
Is a 1986 Chevy 350 engine block the same as a 1996 350 vortec engine block?
no
Is there a block difference between a 1993 5.7L Chevy and a 1996 5.7L Chevy?
No, but if the 96 has the 5.7 Vortec engine then it will have different heads which give it more power. ETA Question: Can I put the '96 vortec heads and intake on the '93 engine? You will need a vortec specific manifold. Edelbrock makes one
Will a block from a 350 5.7 work with heads from a 305 5.0 and 305 intake 1998 If the 350 is not a vortec?
No it Has a different bolt pattern because of the engine size
Will regular old style 305 heads work on a newer vortec 305 block?
The heads will fit the block, but the vortec intake manifold will not bolt to the old style heads.
Do the intake bolts bolt in the top of the block or into the heads on a 305 vortec?
Into the heads only.
Where is the oil pressure sender or transducer on a 1995 Chevy S-10 Blazer with a 4.3 Vortec engine?
Mine is on the Drivers side of the Block, Behind the Intake Manifold.
What year is a Chevrolet 10066061 engine block?
is this a vortec engine 4.3 liter casting number on Block 10066061 - 4.3lg
