Generally, NO. On the other hand, a few motors were designed to be "convertible," in that their original windings were designed to work on multiple voltages by altering the wiring at the junction box terminals on the motor.
If it's not shown on a label inside the motor's junction box you'll need to find the Installation Guide for the motor, either by going on-line to the manufacturer's web site or by asking an electrical parts supplier for the info.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
Unless the ballast is a multi tap primary you can not rewire it for 220 volts.
No, unless the motor was wound for dual voltage operation, which it will state on the motor nameplate, a 110 volt motor run on 240 volts will be damaged.
No. You need to rewire the circuit from the electric panel.
The United States is one of the only places in the world that uses 110 volts instead 220 volts. In order to operate 208 volts on a 110 volt electrical current, you will need a voltage converter.
You don't. A ballast with a 347 volt input is a commercial ballast. The 347 volts comes from a 600 volt three phase four wire Y system. You can change the ballast out to a 120 volt and rewire the unit but in most cases it is cheaper to buy a completely new lighting fixture.
110 volts divided by 1,300 watts(1.3 kw) = .09 kw or 900 watts.
Yes - usually house voltage varies from 110 to 120 volts.
If you combine two 110 volt power lines it does not give you 220 volts, the voltage will be the same. The only way to turn 110 volts into 220 volts is with a step-up transformer.
Yes. Circuits in a home are 120 volts but people tend to call them 110 volt circuits. The 120 volts you read on the appliance is the maximum voltage the appliance can handle. The actual voltage you will read at any outlet will range from 110 to 120 volts.
Typically they are either 220V or 110 volts not both. Plugging a 11o volt blanket to a 220 volt line has a huge risk of fire.
Typically residential voltage may range from 110 to 120 volts so there should be no problem.
NO - that is dangerous.