This isn't a great idea. You likely could if you lowered the frequency to ~40hz (if made to run at 60hz), and cut the load on the motor down to 63% of its' rated hp. You want to keep the volts per hertz equal or near the nameplate values.
No, that is not enough voltage to allow it to run properly.
It would turn without a load, but its performance would be poor, meaning it would not be able to turn much of a mechanical load.
If the voltage difference is less than 5% there should be no problem.
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
no
Yes just connect any line to neutral you have 230volts already.
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
It will probably run but not correctly. Low voltage will cause the motor to draw less amps than it's designed to. It will not reach its rated RPMs and such slow operation may shorten its operating life.
Yes this size motor can be operated by bringing a 600 volt three phase supply to it.
Not advisable, the voltage differential is too great.
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
no
Yes it can run because motors have 10% voltage variation tolerance so it can operate between 380v - 440v band.
Yes just connect any line to neutral you have 230volts already.
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
Yes, it will run drawing little more extra current in similar conditions. The motor is expected to be running in lesser rpm as well.
just connect the supply of motor to power supply..and run..then ovserve the motor sounds,temperature and vibration.
You can use a voltage regulator IC/transistor that can take any input voltage (to a point) and spit out whatever voltage you want, depending on your application (in this case 380 volts) then be sure you build a regulator with the correct IC/transistor. Hope this helps!
To do a motor solo run test you need to connect the motor to a power supply. Next, you observe the motor's vibration, temperature, and sounds.
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?