0
If you are referring to the rear axle assembly then....
Providing both vehicles are either 2 wheel drive or 4 wheel drive I would say "yes".
The reason I made the previous statement is the 4 wheel drive rear axle has a wider track than the 2 wheel drive.
In either case, but especially in the 4WD, the gear ratios should match between the vehicles.
Generally speaking, a manual transmission equipped vehicle will have a different gear ratio than one equipped with an automatic transmission.
Also, if the receiving vehicle has ABS and the donor does not, you will more than likely have an indicator light come on in the instument panel.
If the opposite is the case, donor has ABS and the receiving vehicle does not then there shouldn't be any problems. You'll simply have wires that don't connect to anything if the sensor is on the rear differential.
Hope this helps.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Is a 1995 Chevy s10 v6 and a 1996 4 cyc compatible?
It depends on what parts you want to swap.
Will a 1992 700r 4.3 s10 work on a work on a 1994 blazer?
Need to know which part you want to swap.
Will a 2000 s10 blazer rear bumper fit a 1996 blazeR?
Yes
What is the difference in rear drive shafts for a 1995 and a 1996 Chevy blazer s10?
nothing
Will a 2001 cavalier engine fit in a 1996 Chevrolet S10?
no way i tryed that swap and didnt work ecu computer changed
Where is the drain plug for the coolant on a 1994 s10?
Look at the bottom or rear lower section of radiator
What size is the rear differential on a 1994 Chevy S10 with a 4.3L V6 4 speed auto transmission and 2WD?
The rear differential on a 1994 Chevy S10 with a 4.3L V6 4 speed auto transmission and 2WD has a capacity of 4.1 pints. Use the manual to get more information on the rear differential.
Where can you find a diagram of the rear brake assembly for a 1994 S10 Blazer?
The library should have a shop manual...
What year s10 rear end are compatible with my 1994 s10 4x4 with a 373 posi rear end?
The rears from any GM vehicle of any model year which has that same RPO code should be compatible.
Where is evap canister located on a 1996 Chevy s10 blazer?
Where is evap canister located on a 1996 chevy s10 blazer? It should be found above the rear axle on the drivers side, mounted to the inside of the frame rail.
Will the rear bumper from a W S10 fit a 99 S10?
I don't know what you mean by "W" S10, but the bumper will fit all second generation chevy S10s. The second generations production ran from 1994-2004.
Can you swap a 2.5L out of a 91 S10 into a 96 S10 with a 2.2L?
The swap will work . You may have to change exhaust pipe, swap the ECM with the one from the 91 engine. You are going to have to look and check the wiring harness in the 96 , You may have to swap the too. Probably be easier just to find a used 2.2L.
