In general, any device powered by the fire alarm panel must be listed as compatible with it. There are probably few, if any gas shutoff valves so listed, so probably not.
The normal arrangement for this function is to use auxiliary contacts, either on the panel itself or an intelligent control module to switch an external power supply. This connection should be wired "fail safe" meaning the valve would close if the external power failed.
If you asked this question, you are probably not qualified to design fire alarm systems. This is a life safety system! Get a qualified engineer or NICET IV designer to make sure you have it right. There are numerous codes, standards, and local amendments that must be followed, as well as the manufacturer's guidelines.
yes it will cause it doesnt use the signal to set the alarm or time.
RDI stands for Remote Defect Indication. RDI Alarms comes when a node is not receiving the signal from the corresponding Node, but only transmits. As this Alarm comes on Physical Layer, hence the Alarm can be rectify by cleaning/replacing the Patch Cords/Electrical Jumper Wires.
The function of a water flow switch is to detect water flow in the sprinkler system, usually during a fire event, to signal a local electrical fire alarm, or fire alarm panel to activate the alarm devices in the building,and send an alarm signal to a central station or alarm company to alert the fire department.
false alarm
discrete because the signal of an alarm is periodic.
uses of power failure alarm
Alarm Indication of signal is full form of AIS.
Tocsin
Mabe
background/histor of lihgt alarm
Rabbits
siren; alert; alarm;