yes u can
i used the back of a hamer to "pop" it off
yes i hate long strike
To take it apart you have to unscrew all the screws on one of the sides and it should come apart.
You need to take apart the entire blaster to get the stock off once you attach it. Just unscrew the screwsso that you can take off the top, and take it out. Then screw the screws back in after putting the shell back on. Stinks, huh?
there are two ways you can take a longstrike stock out the first one is to take apart the gun and remove the stock or you can mod it by filing or sanding down the front grooves of the stock. you can check on how to do this on youtube. hope this helps.
If you refer to the Orange double sided bolt, then you can use a hammer to pry it apart. This action is sometimes not reverseable, but fear not modder, because you can reattach it my pouring glue down the hole on the orange bolt piece and stick in the metal rod again. If you refer to the internal cocking mechanism, then you can remove it by unscrewing the back orange piece that is round that holds the spring compressed.
you can but it is hard you have to take apart the gun and pull the stock up and close the gun
Putting your legs apart from each one
If the water or soup you are putting your dumplings in is not hot enough it can cause them to fall apart.
You need a gunsmith
Both are really good They long shot has a lot more modding capabilities but as far as cosmetics go the long strike is the best not to mention the act it holds to clips in the stock and is easy to take apart and re assemble
it can be saved by putting them into a zoo way apart from the other dangerous animal
by putting egg on hairs for 30 mins