Want this question answered?
nothing
No
bungaw..
Wattmeters are used for the measurement of dielectric power loss. It is also useful for the calibration of commercial forms of wattmeter and watt-hour meter in laboratories.
The 'one wattmeter method' can only be used for balanced, wye-connected, loads where the load's neutral point is accessible. The wattmeter's current coil is inserted into any line conductor, and the voltage coil is connected between the same line and the neutral point. The wattmeter reading indicates the power of one phase, so the total power is three times the wattmeter reading.To measure the total power of a balanced or unbalanced wye- or delta-connected load, it is only necessary to use twowattmeters -this is called the 'two wattmeter method'. In this case, the current coils of each wattmeter are inserted into any two line conductors, and the voltage coils are connected between the two line conductors and the third line conductor. The sum of the two wattmeter readings will indicate the total power of the load.
The advantages of wattmeter include adequate for low frequencies, easy to operate and better technology. There are different types of wattmeter and each has specific advantages.
nothing
No
bungaw..
Right-click the Flash part and if it says "Movie not loaded" then it's not working properly.
Yes, they can tell you not to speak it while working, but they have no right to tell you what you can speak on your unpaid breaks or personal time.
Wattmeters are used for the measurement of dielectric power loss. It is also useful for the calibration of commercial forms of wattmeter and watt-hour meter in laboratories.
Blondel's Theorem states that you can have one less wattmeter than there are conductors supplying a balanced or unbalanced load. In either case, the sum of the wattmeter readings will give you the total power of the load.
221
JAMES WATT
Wattmeter is an intrument which is used to measure the power consumption of an Electric circuit or an appliance which is connected to the supply in terms of Watts.
It's cheaper.