Want this question answered?
Decide which flame to use. If the air hole on the Bunsen is open you will get a roaring flame a more gentle heat, close the air hole a Little flame will be quiet.
because you have the vents open on the bunsen burner the flame is getting more oxygen, making it hotter. Different flame types of Bunsen burner depending on flow through the throat holes (holes on the side of the Bunsen burner -- not to be confused with the needle valve for gas flow adjustment). 1) air hole closed (Safety flame used for when not in use or lighting). 2) air hole slightly open. 3) air hole half open. 4) air hole almost fully open (this is the roaring blue flame).
alkaline is used to neutralize acids! like if you get indegestion. If you were to use gaviscon it would have alkaline to stop it from burning/hurting your insides. Alkalis can be very dangerous depending on what part of the pH scale its on its also used in cleaners like bleaches, baking soda,household cleaners.......so basically its use to clean and neutralize
Keep the ozone layer intact. CFC's in the upper atmosphere destroys the Ozone layer and puts a hole in it, allowing more UV radiation in.
When the ship is at the port, the water is shallow therefore we use high seawater suction. If the low seawater suction was used instead, impurities such as sand would be sucked into the system..
You should go and see a doctor. In the mean time try taking some Gaviscon.
I had to punch a hole in the diagram/plug then use a screw to stop the flow and bleed the slave through a pee hole in the port!
They have not found any effects on the fetus but advise you ask your doctor anyway.
Port 53
port 21
Telnet use port number 23,and connected to TCP
Port 80 is the default web server port and IIS would use Port 80 unless configured to use a different port.
port 80 or 27005
Telnet use port number 23,and connected to TCP
connectors are use to connect into the port
Get one of your Pokemon to use HM Cut on it.
There is an inspection port on the side of the transmission. Use a 15/16 wrench to loosen and remove the bolt. Stick your finger into the hole. With the Jeep on a level surface you should feel the lubricant just below the edge of the port.