answersLogoWhite

0


Best Answer

First the maximum charging current for the battery should be checked. If that is unknown it can be taken as one tenth of the capacity, e.g. 2 amps max for a 20 Ah battery

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you use a 2Amp Car battery charger on a 12 volt sealed leak proof battery?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can 5v 1amp charger charge a 5v 2amp battery?

yes


Can you charge a 6 volt battery with a 12 volt battery charger on slow 2amp charge?

No.


Can I use a 12v 2amp car charger for my exide quad battery?

Yes


What is the difference between 2amp 4amp 6amp battery chargers?

The difference between a 2amp, a 4amp and a 6amp battery charger is the speed at which the battery will be charged. The numbers represent the maximum amperage output at a specific voltage at which the battery will be charged.


Is a Intelligent Battery Charger -Motomaster Nautilus for deep cycle batteries the equivalent of trickle charger manual says it does not act as trickle charger can i leave it on for long periods?

Yes it has a 2amp trickle charge


How do you charge a battery on 1300 vtx?

Use a battery charger with a 2amp charge. Takes a few days. These small batteries don't like to be charged too fast with high amps.


How do you charge a battery in a 1989 Honda Shadow?

Remove the battery, or disconnect it, and with any 10 amp/ 2amp, charger, pos to pos, neg. to neg. and charge it at 2 amp, till it is full. If you need to add water, add only distilled water to top the battery up. Use a charger with auto-shut off.


How long do you charge a riding lawn mower battery at 12volt 2amp charger?

Charging time varies greatly, dependent on the batteries condition at the beginning of the charge cycle. Most modern battery chargers are automatic and will reduce charge amps as the battery becomes fully charged. If your charger is a manual type, there are two ways to know when the battery has reached its storage capacity. If you have a volt meter, the battery is at full capacity when it reaches 12.6 volts with the charger disconnected from the battery. Alternately, you can purchase a battery tester, very similar to an anti-freeze tester, which checks the specific gravity of the acid in the battery. Those can be purchased at any auto parts store for a couple dollars. You must have a battery with removable cell covers to test the fluid, most all lawn tractor batteries have removable covers. As a side note, ensure each cell has enough "water" to cover the lead plates by 1/4 of an inch or so.


Can you use a 6V 2amp adapter on a 6V 600mA device?

No. You need to use the exact battery charger for the battery specified by the manufacturer, in order to achieve the correct charge cutoff point. In particular NiCad and similar batteries detect full charge by detecting the knee point in voltage per unit time given a specific charge current. Using the wrong charger could result in overcharge which will damage the battery.


2amp work with 3 amp power?

you haven't asked a question


Im on your third alternator battery stays strong but something continues to kill the alternator ive taken the fuse out of the radio have a new starter and alt belt so?

Kills alternator? don't you mean kills battery? Installing a new alternator without first charging the battery well (2amp for 8hrs) will quite likely burn up a new alternator as well as being hard on the battery.


Wire gauge for 2amp load?

18 guage will do you ok unless you need to run it a mile or two.