Most probably you are using a AC (117V or 220V) to DC 6V converter adapter. If yes, then the answer is no, you cannot use a lower current rating for a device that draws more current. If you plug in a device that needs DC 6V 500 mA to an adapter that can only supply DC 6V 300mA, then the adapter could start sending higher than 6 volts current which may damage your equipment or overheat the adapter.
If you are using a higher mA rating adapter, then it's okay.
For more technical details, see:
http://www.jaycar.com.au/images_uploaded/plugpack.pdf
Yes, as long as the voltages are the same.
No, the maximum that the power pack will produce is 300 mA and will not operate a device that draws 600 mA.
id d0nt kn0w
No. The device will try to draw 700 milliamps which will overload the 300 milliamp adapter most likely causing it to burn out and possibly catch fire.
No, the adapter's power output has to be equal to or greater that the current draw of the device.
The cord your after is a 6V-DC/500MA adaptor.On the York website, you can find out the part number for the adaptor you need.You can find more information at the posted link. However, it may be easier just to head in to a local electronics store and ask about a 6V/500MA DC Adaptor - they should be able to help you out.
Yes, a 9v 1100mA power adapter work with your 9v 500mA device. The mA number is the maximum amount of amperage that the adapter will produce without overloading itself. At 500 mA the adapter will only be working at half load.
No, you will burn out the camera. You can pick up the correct mini spy camera power adapters in the "Related links" section just below this box.
No, a power adapter must supply the same voltage, same polarity, and at least as much current as the load requires. Your adapter can only supply 300mA, which is less than the 700mA required by the load.Your game probably will not turn on and the power adapter may be damaged.
Using a 12v 600ma source is allowing 12 volts and 600 amps of power. If the device requires a 12v 500ma source, the larger source is acceptable. Please note that it will only be drawing on 500ma of the available 600ma.
I think you mean to ask if one can use a 9v 600mA adapter to power a 9v 300mA appliance. Yes, you can do that. A 9v 600mA adapter will deliver 9v at up to 600mA. A mA is one milli amp, or one thousandth of an amp. 300mA is 300 thousandth of an amp, 300/1000 or 0.3 amps. 600mA is 600 thousandth of an amp, 600/1000 or 0.6 amps, and is twice the current of 300mA.
Yes the power pack can supply up to 1 A, so 500 mA or 0.5 A is within that limit.
The voltage would match but the amount of power would likely not be enough to run the device. Under-power will not likely harm the device, but it won't work correctly. Always use the correct voltage/power for your devices!
p=i square x r = 500ma * 500ma = .25 * 4.7k = 1175 watts
No.If it is AC output, it will blow out the power circuits of the DC device.If it is DC output, it doesn't have enough current capacity for the load of the DC device.If you want to power a DC device with a wall wart, make sure the wart is:DC outputCorrect polarity (some have reversible polarity)Exact same voltage as the deviceGreater than or equal to current rating of the device