answersLogoWhite

0


Best Answer

to use 4 wheel drive,both front and rear ends must have same gear ratio.

if you dont want to use 4 wheel drive,u can change rear ratio,but remove front drive shaft so as not to accidently engage 4 wheel drive and trash your transmission

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you use a different gear ratio on your 2003 silveradoit has a 373 gear4 wheel drive and disk brakesdont have to have 4 wheel drive want to know What is compatiable due to your rearend went out?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you use a different gear ratio for rearend?

yes, but not if 4wd


How do you increase tow capacity?

Get a heavier duty rearend. the tow capacity is based on the rearend. Chevy 10, 12, and 14 bolt rearend.


What kind of rearend came in the 1969 impala?

In 69 you could get whatever you wanted, a lot of impalas had the 12 bolt rearend and some had the 8.5 10 bolt rearend.


Can you put a rearend out of a 2002 dodge ram 1500 4x4 in a 2001 dodge ram 1500 4x4?

No, different type of springs.No, different type of springs.


What kind of rearend does a stock 96 ford bronco have?

what kind of rearend does a stock 96 ford bronco eddie bauer have.


Are the brake pads the same for front and rear disc for 2002 trailblazer?

no ,plus there are different sizes on the rear,because of multiple rearend sizes


Will a 06 rearmed fit an 05?

Rearend


Who makes the Dana rearend?

Dana i believe


How do you remove ans Axle from a 2000 camaro?

take all the bolts out of the rearend pumpkin cover and you will see the rearend gears, push the axle inwards and you will see a C clip that holds it in place inside the rearend, pull the C clip out and then you can pull the axle out.


Where are the brakes on a mtd yard machine?

The brake is on the rearend. Depending on what year the mower is will tell you which side of the rearend it is on. More recent mower will have it on the right side of the mower. You should be able to look under the mower just in front of the right rear wheel and see the rod going from the linkage to the rearend. It goes through a lever on the rearend. There is a nut where that pivots. If you tighten that nut it will adjust the brake.


What size rearend is in a 2000 Chevrolet Z71?

8.6


Does a 1988 4.3 s10 blazer have a posi rearend?

no