It's not prohibited in Canada.
It is tricky but u can with a fernco if the copper dwv drain line is 1 1/2" in diamater use a 1 1/4" x 1 1/2" reducing fernco because the outside diamater of copper is smaller than abs or PVC
No, it will not glue it, just dry up and become flaky. You must use a proper glue for each plastic. - Yellow glue is only for ABS.
Abs to PVC glue sold at home depot Color it aqua blue/green plumbers key term. GUMBY GLUE Depends upon what you mean by "black pipe". If you mean ABS drain pipe, there is glue for that. If you mean steel "black pipe", i.e., non-galvanized, then you would need a threaded connection adapted to the PVC (either a female PVC connector on a male black pipe or a male PVC connector into a female black pipe fitting). The secondary question would be, "Why would anyone want do to that?"
I don't quite get what you mean. -A vent pipe in a plumbing system is usually 1 1/2 inch ABS pipe and may extend through the roof, or may end in a AAV under a countertop.
DWV is on pipe. Drainage, waste, and vent.
dvw pipe = drain, waste and vent pipe.
Yes, if you roughen up the ABS and use epoxy, not ABS cement.
No it is not ok. ABS is affected by the heat coming out of a dryer. The usual metallic flexible pipe is cheaper anyway all considered, so why would you want to use ABS.
Acrylonitrile Butadiene Styrene (ABS) pipe is a black plastic pipe often used for sewage pipe.
You don't. You use preformed elbows.
Black plastic pipe is ABS -Use yellow ABS cement. -I don't understand "grey bard fitting" -Take this to your plumbing store and they will advise.Black plastic pipe is ABS -Use yellow ABS cement. -I don't understand "grey bard fitting" -Take this to your plumbing store and they will advise.
Schedule 40 Foam Core pipe can be used for DWV systems, and Schedule 40 pressure rated pipe (PW) should be used for water lines, and can also be used for DWV. CPVC can also be used for water lines.
Most plumbers today no longer use coper "pipe" or TP copper as the cost is to high=What plumbers and HVAC and other trades use is Copper tubing types K, L, M, DWV, ACR=
ABS yellow glue is the correct glue for ABS pipe. The only other glue to consider is Weld On Transition cement if you are gluing ABS to PVC parts.
Detect the leak and replace that part of the pipe. It is usually better to replace the whole piece of pipe. By removing the junk plastic and replace it with quality piping such as copper DWV or NHCI
What is actually broken the flnge ring rusted out and broke or the abs pipe? Abs pipe/flange broken: Use a ram bit to cut it out and install a new one. http://www.plumbingsupply.com/pvcsaver.html use a compression or expansion flange http://www.plumbingsupply.com/toiletflanges.html or just cut the pipe and put in a new one Flange ring rusted/broken: install a toilet flange repair ring or a spanner flange.