answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Can you use an ignition coil from a 94 ford probe gt and use it on an 89 ford probe gt turbo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the ignition coil in a 1995 ford probe gt?

Built into the distributor.


Where is the coil on a 1993 Ford Probe gt?

On the '93-'97 GT's the ignition coil is part of the distributor. If your coil goes bad you need to change the distributor.


Can a turbo from a 1989 Ford Probe be used on a 1989 Ford Probe non turbo?

if you have the exhaust manifold, oil lines, etc. from the 89 GT then yes.


What is Ignition timing 1990 Ford Probe 2.2?

motorcraft.com shows for the 1990 Ford Probe 2.2 L ( 133 cubic inch ) 4 cylinder : ignition timing : 6 degrees BTDC , and --------------------------------------------------------------------------------------------------------- 9 degrees BTDC - manual transmission - with turbo - with self test connector grounded


What is ford 5.8 ignition coil restance?

What is there stance specifications on an ignition coil for a ford 5.8 f250


What transmissions and years are compatible with 1995 ford probe gt 2.5 6 cylinder turbo?

The 1995 Ford Probe, either the GT or the 4 cylinder DID NOT COME with a Turbo.


Where is the ignition coil located on a1985 ford 4.9 with efi?

Asking "Where is the ignition coil located on a1985 ford 4.9 with efi?"


Where is the dura spark ignition module located on a 1991 Ford probe?

The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Why does Ford Probe ignition stays on even when key is not in ignition?

Defective ignition switch or tumbler assembly.


How to replace ignition coil in a Ford Focus?

http://www.ehow.com/how_4509339_replace-ignition-coil-pack-ford.html


How do you set ignition timing on a 1989 ford probe?

where are timing marks on 89 ford probe 4 cylinder I have the bottom not the top


Would it be hard to install a turbo on an 1996 ford probe gt?

yes