Yes, you absolutely may use copper pipe for Oxygen service. There are, however, several things that must be taken in to consideration.
First of all, any piping that will carry Oxygen MUST be cleaned in accordance with CGA G-4.1. If there is any oil / hydrocarbon residue in the pipe and pressurized oxygen hits it with any force there is a high probability that the oil may ignite. You should purchase tubing and fittings that are cleaned and bagged for Oxygen service.
Second, you need to keep in mind that copper tubing is for relatively low pressures. The pressure rating is also dependent upon the method used to join the copper.
If the copper is intended for cryogenic oxygen service, a high silver content brazing alloy should be used. Also, whenever brazing you should have a constant purge of dry nitrogen flowing through the pipe - this will prevent oxidation / scale inside the pipe.
After assembly you should pressurize the system with Nitrogen and use a bubbling leak detector that is OXYGEN SAFE to check for leaks. Whatever method is used to join the pipe, you must be certain that there is no contamination (oil, flux, etc) inside the pipe before the system is pressurized with Oxygen.
NASA Standard NSS 1740.15, "Copper is suitable for use in oxygen systems at all pressures."
No you cannot. Copper Pipe only
You can use copper pipe.
Flare copper pipe and use a flared shutoff valve. If valve isn't flared, use an adapter fitting between copper flared pipe and valve.
It is not a good idea to use copper pipe with natural gas as any sulphur compounds in the gas can cause an oxide to form in the copper pipe. Often copper is used with propane. In these instances, soft copper tubing is usually used with compression fittings. The tools required are, pipe cutter and 2 wrenches.
It is probably referring to the type of fitting. A fitting that is soldered to a copper pipe. It is called sweating when you use solder and a torch to connect copper pipe together or attach fittings to copper pipe.
Galvanized pipe will be silver/gray color. Copper will be copper. Use a magnet, it'll stick to galvanized pipe but not to copper. Drinking water lines should not be black steel pipe.
Use a lead-free silver solder. It is the only thing that can handle the pressure and bond with the copper pipe.
If you had been advised why ask again?
What kind of pipe, the inside or outside, or a tobacco pipe? If it is copper pipe, you can use an emery sand cloth or steel wool.
Most plumbers today no longer use coper "pipe" or TP copper as the cost is to high=What plumbers and HVAC and other trades use is Copper tubing types K, L, M, DWV, ACR=
A copper pipe is a conductor :) x
By use of male or female, teflon paste or tape or leak block and then use A COPPER X MALE OR COPPER X fEMALE ADAPTER
Not directly without some type of sleeving or protection between them. They are dissimilar metals and it will create electrolysis which will severely impair the copper pipe and create holes in the copper in the future.