idk, ask your science teacher(:
glad i culd be of survice
In an incandescent light bulb the wire that gives off the light is called the Filament.
Take two pieces of wire, one battery and one light bulb. Battery and light bulb should be the same voltage. Attach one end of one piece of wire to one pole of the battery (Soldering it would be best). Attach one end of the other piece of wire to the other pole of the battery and the other end of the wire to side conductor of the light bulb. You are done. To test the conductivity of something you simply touch the center conductor of the light bulb to one end of what you're testing and the other end of the first piece of wire to the other end of what you're testing. If what you're testing conducts electricity the current will run from the battery through what you're testing into the light bulb, out the other side of the light bulb and back to the battery and the light bulb will light up. If what you're testing doesn't conduct electricity, the electricity from the battery will not be able to pass through it to the light bulb and it won't light up. Good luck!
In most home wiring circuits, the black wire is used to power a light bulb. The other wire is white and is called the neutral conductor.
You are thinking of a filament.
As the name implies, support wires support the filament wire in the bulb, The filament, of course is the wire that glows white hot, giving out light
first of all, you need a bulb, a wire, and ONE light bulb. You clip the wire on the battery and touch the wire on the bottom of the light bulb
When connecting a volt meter to a light bulb to measure the voltage of the light bulb, run a third wire from where the wire enters the bulb to one terminal of the voltmeter and a fourth wire from the other side of the bulb to the other terminal of the voltmeter.
When one wire or terminal is not connected to a light bulb, it is not possible for electricity to complete the circuit. When a circuit is not completed, the bulb will not light. An off switch, for example, breaks the circuit.
When connecting a volt meter to a light bulb to measure the voltage of the light bulb, run a third wire from where the wire enters the bulb to one terminal of the voltmeter and a fourth wire from the other side of the bulb to the other terminal of the voltmeter.
In an incandescent light bulb the wire that gives off the light is called the Filament.
Get your bulb, it should be a very small wattage (weak) one, get your battery and wires, connect one wire to plus side of abttery and other wire to minus side of battery, then connect to the bulb, you may have to play around a bit to find a connection that produces light.
the wire in your light bulb is a resistor :)
Take two pieces of wire, one battery and one light bulb. Battery and light bulb should be the same voltage. Attach one end of one piece of wire to one pole of the battery (Soldering it would be best). Attach one end of the other piece of wire to the other pole of the battery and the other end of the wire to side conductor of the light bulb. You are done. To test the conductivity of something you simply touch the center conductor of the light bulb to one end of what you're testing and the other end of the first piece of wire to the other end of what you're testing. If what you're testing conducts electricity the current will run from the battery through what you're testing into the light bulb, out the other side of the light bulb and back to the battery and the light bulb will light up. If what you're testing doesn't conduct electricity, the electricity from the battery will not be able to pass through it to the light bulb and it won't light up. Good luck!
filament
the Sparks on the copper makes the wire on the light bulb makes the 9v light bulb turn on.
Make a circuit with 2 wires a batery and a light bulb and touch wire to medle on light bulb
its the light was not appeared but not all are us a bulb to have possible to the light when it is open they conssume to another part that they..