0
Yes, but... you will need wire heavy enough to carry the current [measured in Amperes or Amps] that the horn uses, and also need to install a control switch in the circuit or the horn will sound continuously. The hookup is simple: one horn wire to the Positive [+] terminal and the other horn wire to the Negative [--] terminal.
It would also be a very good safety practice to install a properly sized fuse in circuit to protect the conductor wires.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you wire up a car horn and button?
To wire up a car horn with a button you first need to run one of the wires from the horn to the battery. Take 1of the wires from the horn and run it to where you want the button to go. Connect the wire to the button and that's it.
How do you make the horn work?
hook a wire up to the (+) side of the battery and put it to the horn if the horn blows it a good horn if not replace the horn
What battery wire to you hook up first in a car battery?
Hook positive up first, negative last.
How do you replace horn in 1997 chevey cavalier?
Jack up the rider front side of the car. Remember to follow all safety guidelines for jacking the car into the air, and as always put on your rear brakes to further secure the car from rolling while your under it. From the front riders side get under the car and look up right behind the bumper, and you will see the horn attached sideways to a bracket. Unscrew the one holding nut, and then disconnect the wire from the horn assembly. Pull the horn out, and that's it. To check to see if the horn itself is faulty, use a jumper wire to jump the connection to the battery. Assembly is the reverse of disassembly.
What side of a car battery do you hook the power cord up too when setting up an amp?
RED wire goes on +, and the black wire gets wired to the body of the car. Which is ground -
Why are some car cigarette lighters non functional when the ignition is off?
Because they are not hooked up to a battery wire they are only hooked up with an ignition wire.
Will a 95 dodge neon stay running if you disconnect the negative battery wire?
it should because car is running off alternator and if you do this it will not charge battery back up
What if you hook up battery backwards on 2006 Honda Odyssey. Now that it's installed properly and the battery still works nothing works on the car except the horn. Car won't turn on. Fuses are fine.?
I would check the weiring harness from the car to the starter
When I Started car turn on lights car stalled wont start up now no lights horn fuel pump radio?
if that's the case then you battery might be dead take it down or get if you have a battery charger use that to get it going it usually takes about 18-24 hours to charge up a car battery. Type your answer here... If your car stalled when you turned on the lights, it could be that a fuse was blown.
What happens if you leave a wire hooked to a battery to long?
The wire will heat up and melt and the battery may be damged.
How do you replace horn switch on a 1997 ford F-350?
you have to buy the complete unit ,airbag and all, about 500.00 just wire up a separate horn wire
Horn not working on 1993 Jeep Wrangler 1993 Jeep Wrangler?
most likely if you have ever had your top off. you need to pull the horn button straight up off the steering wheel, and clean the contact points with a wire brush or Emery cloth. The water may have corroded them. It is what happened to mine. Also check fuses and horn. take a wire and go from battery straight to the horn or use a volt meter to make sure voltage is getting to the horn. If it honks it is your connections under your button, if not it is your horn.
