The car probably ingested water into the cylinders.When this happens it tends to bend piston rods and may cause bearing damage.Water does not compress like fuel and air.therefore the engine suffers.It can be fixed,it will need to be disassembled and inspected,it will probably need rebuilt.
check the ignition coil probably becomes open circuit when hot
When the oil light is on, it means you have low oil pressure. This can be caused by low oil level. When you first start the car, the oil light will come on momentarily, then turn off to signify that proper oil pressure has been reached. An engine knocking usually indicates that the engine is about to stall.
Yes.
check to see if a/c compressor is locked up.
When a Chrysler Sebring is stalling it is possible that poor gasoline has been used. It is also possible that the car needs the spark plugs replaced.
Car will stall, rpm goes to 0. Starts back in minutes. As it gets worse it will take longer to start, and wait times will be longer. You lose power steering, and brakes so this needs to be fixed..
I ow a 1997 Chrysler Town and Country. I have many electrical issues. But, mine will stall in the middle of the road sometimes. There is an engine fuse (20)amp, in the main fuse box to the right of the engine. This has blown on many occassions. You could start there.
Start and stall out, possibly. Not start at all, not likely.
It could be fuel related such as a weak fuel pump, plugged fuel filter, water in fuel, bad fuel pressure regulator,
Another possibility is loose or corroded wiring connections.
haha. UH...yes. everything with a motor can stall, and will eventually unless you take really good care of it. MOst of the time it will only stall if your low on gas, oil, or have a really dirty air filter. but they are things that can be fixed, and are very cheap at the moment. your welcome Any Questions email me at Andrewsplace1905@aol.com Subject(WIKIGOKART)
Just fixed this, was a loose vacuum line next to intake