answersLogoWhite

0


Best Answer

1. Rotate spool to line up arrows on spool and surrounding casing. 2. Find notch and pry with wide flat-end screwdriver. 3. Spool will pop out.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Cant get the spool out of a craftsman line trimmer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can you replace the trimmer line mac 2816?

Locate the trimmer head at the shaft. Remove debris in the head. Cut a 14-inch piece of the trimmer line and fold it. Place the spool against the spindle. Feed the ends of the line through the eyelets. Push the spool down and pull the trimmer line tight with your hands. Tighten the spool.


How do you change the trimmer line on a 5 HP Briggs and Stratton trimmer mower?

craftsman


Where can you get an owner's manual for a Craftsman line trimmer?

http://userguides.50webs.com/


Craftsman 32cc Gas Line Trimmer Manual?

How do you rewind the rope on the moter


How do you repair pull cord on homelite trimmer?

The pull cord on a Homelite trimmer is repaired by removing the outer cover and pulling out the cord spool. A new line is then attached, wound around the spool, and put back in place.


How do you replace the line on a spool with two lines coming out of the spool?

Cut two pieces of trimmer line about 6-8 ft long. Push the line into the opening in the spool until it comes out of the bottom of the spool. Place the end of the line into the small hole adjacent to the opening where the line came out of the spool. Pull the line tight while holding your finger on the line in the hole. Do this for both sides and then wind the spool in the reverse direction to fill the spool. Pull on the line occasionally to make sure the line is not binding up in the spool. There are spools that will take one single long line, where the center of the line is attached to a notch (or similar) in the center of the spool and then wound with one line on each side of the spool. Then, the end of each line is threaded through each hole in the trimmer head. It would be best if you consulted a user's manual. Try the following website for a downloadable manual for your application: managemylife.com or manualsonline,com


How do you attach a throttle cable on a craftsman line trimmer?

http://www.howtomendit.com/questions.php?id=62&page=1


What is the gap setting for the spark plug on the Craftsman 32cc line trimmer?

on most trimmers the gap is about 25 thousands !!


Craftsman 32cc line trimmer stop after is hot and not star no more?

Failed ignition, though it could have fouled the plug.


Fuel line diagram for a craftsman 32cc weed wacker?

Mine had a guide hole that broke so I took a small piece of tubing for the fuel line and glued it inside the spool for a guide to start the line, end of line goes inside the guide and wraps around spool


How do you string a dual line kawasaki ktr27a line trimmer?

Wind the line clockwise on spool holding the bump knot in the palm of your hand, twist bump knob so that the line goes on clockwise this is according the the dealer


Manual for Craftsman 31679116?

Go to Sears.com, then at the top of the page, click on Parts Direct. A box will appear where you can enter the Model #. On the page that comes up, click "View Manual". A .pdf file will open which you can save to your computer.