does it have a child proof lock syetem that locks from drivers door?
with a brick
The Drivers Door Module or Passenger Door Module on a 2003 suburban is also known as the "window / door lock" switch. These modules are located on each respective door, i.e. driver side door or passenger side door. It is the module that has the door lock/unlock switch and window up/down switch. Hope this helps...
remove the inner door panel, you can access the bolts from the inside of the door.
in a plastic pot in the passenger door or drivers door......
If the electric door lock is frozen on a 1999 Suburban, a hair dryer can be used to warm the area of the door where the lock mechanism is. If the key entry is also frozen, there is a lock de-icer pen that can be used to spray away frost in the keyhole.
On my 1996 Suburban which is pretty much the same as you're 99. The rear condensor is located at the back door. When you open the door the shelf on the right side is removable. You will see the slots at the end of the carpeted area. That is where the rear condensor is.
Depends on what's wrong with the door.
To remove the door of a 1999 Chevrolet Suburban, first, ensure the window is fully closed and disconnect the battery to prevent electrical issues. Remove the door panel by unscrewing any screws and carefully prying it off to access the door's internal components. Disconnect the wiring harness and any supporting brackets, then remove the bolts securing the door to the hinges. Finally, carefully lift the door off the hinges to complete the removal.
It is located on the passenger side dash , where the door and dash meet on the side
you have to unlock the passenger door from the outside with the key
With the front door open,the handle is inside the front of the rear door .Pull handle out .
You can fix a sagging door on a 1996 Suburban by replacing the door pins and the bushings.