0
You must remove the instrument panel. There a several forms that show how to remove the panel.
The bulbs are in plastic holders. They are a wedge base bulb and pull straight out of their holder. The gauge illumination bulbs are #194. Don't believe the bit of all bulbs are #194. The warning light bulbs are a smaller bulb. I think they are a #73.
Both these bulbs are available from Mouser electronics under a dollar. To remove the bulb holder just twist counter clockwise. Takes a lot of force.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Who to Change engine check light bulbs on a 1996 BMW 318i?
Who to Change engine check light bulbs on a 1996 BMW 318i?
How do you replace the headlights on a 1996 VW Golf?
the whole light or just he bulbs?? just the bulbs
How to replace the third brake light on 1996 Chrysler sebring convertable?
I assume you only need to change the bulbs. Go into the trunk and look up. You should see the wires leading to the mounting point for the third brake light, you candisconnect the connectors and then change the bulbs this way.
How do you change the bulbs in the top tail light of a 1996 Nissan Altima?
open your trunk to get access to your tail light, unscrew some plastic snap-on-screws to get to the panel that holds all your tail lights move the fabric uncling the panel CAREFULLY and change your burn bulbs
How do you change the tail lights on a 1996 Ford Thunderbird?
You have to replace the entire light unit. The bulbs are not replaceable. Try a junkyard or Ebay for used units.
How do you change the brake light on a 1996 Lincoln Mark 8?
If you are referring to the right and left ones, pull the carpeting away and you will find like 4 nuts that you remove and the whole assembly comes out to change the bulb or bulbs. The 3rd brake light in the rear window has two bulbs which you get to from the trunk. If you are referring to the right and left ones, pull the carpeting away and you will find like 4 nuts that you remove and the whole assembly comes out to change the bulb or bulbs. The 3rd brake light in the rear window has two bulbs which you get to from the trunk.
How do you change tail light bulb on 1996 ford crown Victoria?
open trunk, remove the 4 wing nuts, remove the casing from the outside. Bulbs are in there.
How do you change the brake light on a 1996 Mazda MX6?
open boot/trunk undo 2 screws on top of rear lens and slide out replace bulbs and refit
1996 ford ranger xlt has no heat how do you fix this?
change the thermostat
How do you change the headlamp bulbs on a 1996 Acura TL 2.5?
The headlamp bulbs on a 1996 Acura TL are installed from the engine bay. Find the housing located in the front of the vehicle. Disconnect the bulbs and replace them with new units.
How do you change brake light bulb in 1996 ford crown vic?
Trunk open, remove the 4 wing nuts on the casing. The casing will pull off from the outside. The bulbs are in there.
How do you change a front fog light in a 1996 Pontiac Bonneville?
'How do you change a fog light in a 1996 Pontiac Bonneville? ... How do you
