Check engine light stays on in 1999 acura integra?
your check engine light comes on for many reasons. the light comes on because the ECU(car computer that controls and monitors) recognizes an error and has stored an error code. some causes could be small problems but some can be huge problems. first you need to trace your steps back. what types of repairs did you have done to it. did you start your car with the gas cap off? this could cause the check engine light to come on in some vehicles. the most common cause ive seen are, left gas cap off, O2 sensor, and misfires. you can drive your car to Autozone or Advanced Autoparts and they can plug in an OBD2 scanner and tell you what code has been stored in the ECU. after you find out what the code is it will give you an idea of what is wrong. start there
How do you fix a broken speedometer in a 1996 Acura Integra it stays on 0 would that have anything to do with the check engine light coming on?
Why would a 1993 Acura Integra turn over but not fire up until a few minutes later there's a click and then the Check Engine light clicks off and the engine fires up without problem?
I had the hood open when my Acura did this and heard a slight hissing from the Fuel-Injector. Then the "check engine" light clicked off and the engine fired right up. I'm working on a 1990 integra did the same thing and I have to say there is a loose connection in the Main relay it's under the kick panel under the steering wheel 10mm bolt burnt brown color it will say something like mitsuba…
Where do you look on a 1990 Acura Integra if your AC quit and you do not see any blown fuses and the AC light does not come on when you press in the button on the dash?
Could a timing belt that was just replaced be off when a 1989 Acura Integra does small jerks and the check engine light comes on while on the freeway after replacing it and the water pump?
The idle on all fuel injected engines is controlled by the engine control module. There are no adjustments to be made. If your idle is high it could be caused by a vacuum leak or a sticking or bad idle air control motor. If you have a check engine light on then you will need to have it scanned for codes.
Go to the fuse that is on the battery terminal, and remove it for about 20 seconds, then put it back in. This will reset the ECU which will rid you of the check engine light. If the problem that caused the light to come on is still present the code will be set in the ECU and the check engine light will be turned on again until the problem is corrected.
theres a box on the underside of the dash below the steering wheel, run your hand along the bottom of the panel and you will feel it, or get under and look. when you find it turn the ignition into the on position and press down the button for a couple of seconds until the light comes off, turn the key back then start your car, light should be off.