answersLogoWhite

0


Best Answer

Sounds like you have a head gasket blown. Check the oil to see if you have any water in the oil. If not that is good. You can also remove your spark plugs one by one to see which gasket is blown, whether it be your drivers side or passenger side. Hope this helps.

User Avatar

Wiki User

โˆ™ 2008-07-15 20:24:49
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Chevy truck water coming out tailpipe a little white smoke but it runs fine but if you let idle for about 1 hour it shuts down but it will crank right up help?
Write your answer...
Submit
Related questions

Where is the crank sensor on a 2005 Chevy Impala?

where is the crank sensor located on a 2005 chevy impala


Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?

Chevy did not use a crank sensor on that year.


Where is crank sensor locted on 1993 Chevy lumuna car?

trying to locate crank shaft sencor for 1993 Chevy lumna trying to locate crank shaft sencor for 1993 Chevy lumna


Will a Chevy 350 crank fit in a Chevy 305 and what it make the engine with a stock bore ofcourse?

a Chevy 350 crank is a Chevy 305 crank. they have the same stroke, 3.48 inches, and are interchangable. swapping between the two cranks does not change the engines displacement


Is the crank and flywheel balanced on a 350 Chevy?

Just the crank. The flywheel is neutral.


Will 350 Chevy main bearings fit 283 Chevy crank?

No.


Why is blue smoke coming out of tailpipe?

Blue smoke is oil smoke, sounds like you need an overhaul. either the piston rings or valves are allowing oil to enter the combustion chamber. because when you crank it oil also comes out


Where exactly is the 2000 Chevy Impala crank shaft sensor?

install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft


Where is a crank sensor for 95 Chevy Suburban?

A crank sensor was not USED on a 1995 model.


How do you replace the window crank on a Chevy lumina 1997?

Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.


What is the Location of crank shaft sensor 1992 Chevy truck?

That year model does not have a crank sensor.


Where is the small c clip that holds the window crank on a Chevy aveo?

behind the window crank


Crankshaft sensor for a Chevy Lumina?

Where is the crank sensor on a 95 chevy lumina car ?


Does a 1995 Chevy Camaro Z28 have a crank sensor?

No it does not


How do you build Chevy big block?

how to installed a crank


Can you bypass a crank sencer on a 1997 Chevy truck?

No you can not.


Crank sensor location 84 Chevy 2.0?

They did not use a crank sensor in 1984, There was no need for 1


What is the difference between a 350 Chevy crank shaft and a 400 crank shaft?

400 has a longer stroke


What Chevy small block has 3.625 stroke crank?

its s stroker crank that makes the 350 a 364


What are symptoms of a bad camshaft sensor in a 2000 Chevy Tracker?

when my camshaft sensor was going bad, the vehicle refused to crank after being driven and parked for a few minutes. If you wait a little while it may crank. I heard of people pouring water on the sensor casing to crank them also.


Does a crank sensor have anything with starting on a 96 Chevy vortec?

if the crank sensor is bad it does not tell the computer that the crank is turning it will not fire up the engine.


How do you remove a crank sensor on a 1997 Chevy blazer?

First find the crank sensor and then kick the crap out of it :D


If the crank sensor is bad in a 2002 Chevy truck how does it act?

The starter will crank the engine over but it won't run.


How do you remove the window crank on a 95 Chevy Cheyenne?

There is a c-clipthat holds the crank in place,you just need to push it off and the crank comes off.


What is the crank rotation for a big block Chevy?

From the front, clockwise.