0
9 3 1 6 8
7 5 2 4 10
This is a generic sequence that will always work (excluding torque-yield bolts and exotic compression-type gasket materials, though it should work fine if you have a torque/rotation spec). Always start at the middle and work outward concentrically as shown. Start at 1/4th the torque specification and repeat the sequence incrementing 1/4th of the spec each time. After the full torque iteration, repeat at full torque until all the bolts quit turning. Voila.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Head bolt torque and removal sequence for 1994 Nissan pathfinder?
The 1994 Nissan Pathfinder had bolt torque specification is 140 pounds. There is not any removal sequence. There is only a sequence to put the bolts in.
What is the torque sequence of main bearing caps for 350 chev 4 bolt main?
the torque is 70 ft. lbs., but as far as I know there isn't a torque sequence.
97 350 head bolt torque?
your local auto parts store can give you a print out of the bolt installing sequence and torque specs
Head bolt torque specs for 2003 Chevy Malibu?
I need head bolt torque specs and sequence on 2003 Chevy Malibu 3.1
What is the head bolt torque for a 1996 S-10 4.3L?
your torque spec will be 65ft.lbs. Make sure you have the torque sequence too.
What is the head bolt torque sequence for 1990 Chevy Corsica?
criss cross
What is the head bolt torque and sequence on a 1990 Honde Civic DX with a 1.5 liter engine?
Tightening torques Cylinder head Honda Civic 1.5 1988-91 Stage 1 Tighten: 30 NM Stage 1 Tighten: 68 NM
Can you find Citroen saxo head bolt torque sequence?
look in te manual :-)
What is Chevy 454 exhaust manifold bolt torque install sequence?
40 lbs
What is fiat punto head bolt tightening sequence and torque?
It is important to know the head bolt tightening sequence and the torque of a vehicle. For the Fiat Punto it is 20nm, 30nm, 90 degree turn, 90 degree turn, then in order 8,6,2,5,10,7,3,1,4,9.
GM 3.1L V6 head bolt torque specs and sequence?
5 3 2 87 1 4 6 3.1 cylinder head bolt sequence
What is the head bolt sequence and torque setting on a rb30e?
Torque is 76Nm from memory and you will require a 10mm Allen key wrench drive
