0
Blower motor is going bad. They are usually behind glove box area.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What part makes a clicking noise next to the Blower Motor in a 1998 Chevy Silverado?
it is the blend door in the duct system
Where is IAT sensor located on 2006 Chevy Tahoe?
It is in the air duct hose coming from the air filter box and going to the throttle plate housing. It is up by the air filter box and poped into the air duct hose.
How do you fix the leak in the top of my Tahoe?
Duct tape works every time
Where is the throttle position sensor on a 2003 Chevy Tahoe with Vortec engine?
It is the bottom sensor on the right side of the throttle plate housing. That is the part that all the duct work comes from the air filter box and hooks to the engine is.
What would cause a vibration noise in air return duct?
apples
Where is a map sensor on a 1998 Chevy Tahoe?
Check for the Manifold Abosolute Pressure (MAP) on top of the intake manifold. In the 5.7 engine it is located right behind trottle body. You have to remove all the intake air duct to get to it. Good luck, Tizo
What type of duct system would be used if an attic mounted air handler was located very close to all of the branch duct termination points?
reducing trunkline system with duct liner and acoustic flex duct to minimize noise.
Would duct tape stop the noise of glass being broken?
if you have enough of it then yea, it shouldwork
Where is the IAT sensor located on 2006 Chevy Tahoe?
The IAT ( Idle air tempture sensor) is part of the mass air flow sensor, It is in the air intake hose coming from the air filter box to the engine. It is up close to the filter box but in the air duct line.
What causes a clicking sound under the wood floors in your home?
The clicking noises are caused by the duct-work under the floor. When hot or cool air is run through them, the duct-work will either expand or contract with the temperature change, making clicking noises at the joints to adjust for the expansion/contraction. The other possibility is there is a loose floorboard where a nail missed the joist, and the floor creaks when you walk on it.
How do you calculate the aspect ratio of a duct?
The aspect ratio of a duct can be evaluated as the ratio of width to height. As the aspect ratio increases, vibration noise, friction and cost also increases.
How do you make cowboy boots not make noise?
Cowboy boots do not make noise when you are walking on loose sandy soil, which is what they are designed for. Walking on a hard surface they will always make noise, nothing can be done about this.
