Want this question answered?
There is not a colour code system as such on Peugeot's Near to the end of the wire is a number this is the code.
The ribbed wire on a lamp cord is the neutral wire. On an extension cord there is no rib but the neutral wire is white in colour.
green and black , as your looking at it its the furthest left.
The type of wire you are looking for is called lamp cord. It comes in different colours usually to match the fixture. Fixtures hanging from chains use a clear insulation so as to blend in with the fixture chain colour. Remember that the smooth wire of the lamp cord connects to the hot wire and the ribbed wire on the lamp cord connects to the neutral wire in the ceiling junction box.
Most lamp wire is parallel #16 conductors.
eHow is a great resource for topics like this, with articles like "How to Re-Wire a Lamp," "How to Rewire a Lamp with a Rotary Switch," "How to Rewire an Old Lamp," and "How to Wire a Floor Lamp."
In a floor lamp or table lamp a #16 wire is what you need.
If you are asking about the electrical cord on a lamp, the black wire with the white stripe is the neutral conductor.
The hot wire on a lamp cord will be the the side that has the more narrow prong on the plug-in. Or you can look at the cord and whichever side is smooth, (not ribbed but smooth), is your hot wire.
No! Most lamp cords are made with 18 guage wire, some speaker wire is made with 18 guage wire too but the insualtion of the wire is very different. Both wires have insulation for their intended uses. Supplying a lamp with line voltage and supplying a speaker with low voltage are very different. The speaker wire is not meant to carry line voltage and may overheat and or melt.
The best way to find the neutral wire on any lamp is to ring the wire out. Before there were polarized plugs and receptacles a lamp could be plugged in either way. All new lamps have polarized plugs where the neutral is connected to the shell of the lamp holder and the "hot" wire is connected to the center pin deep in the lamp socket. Back to your goose neck lamp, you will need a meter that reads resistance and use it as a continuity meter. With the lamp unplugged and the lamp's switch in the off position connect one lead of the meter to the shell of the lamp holder. Take the other lead and touch it to one of the plug cap blades. If the meter gives a reading it is that blade that is the neutral wire. If there is no reading then that blade is considered the "hot" wire. If you are changing the plug (cap) out for a new one connect the newly established neutral wire to the silver coloured screw and the newly established "hot" wire to the gold coloured screw. Now when ever and where ever the lamp is plugged into a voltage source the polarity will be correct and the lamp will be much safer to use.
pokemon platinum uses it