You take a wire and stick it to the positive end of the batter. Then connect another wire to the negative end of the battery. Connect both wires to the lightbulb.
you take the socket and plug the flasher into it
you take the blue wire and connect it with the red then connect it to the yellow then you cut the green wire and there you go!
The proper way to connect a second starter wire depends with the configuration used.
Volts * Amps = Watts 12 V * ?Amps = 100 Watts OR ? Amps =100W/12V OR 8.33 Amps = 100W/12V Use a 10Amp fuse inline and you can get by with 16Ga wire.
Connect the sub woofer to the equalizer or amplifier. The positive wire will need to be connected to a power source. Connect the ground wire. Connect the auxiliary wire to the amplifier.
Amp always on
12v switched source. such as headlight switch or dimmer on the dash.
what is meant by "car audio"? an amplifier will not turn on if it is missing either ground, 12v or 12v accessory turn on. the respective wire colors will be large red wire for 12v battery source, large black wire for -12v ground battery or chassis, thin blue wire for accessory 12v turn on. these wires can be tested for 12v with a multi-meter or a simple test light. a car radio is basically the same wire design for power up, most radios will need 12v to the yellow wire, accessory 12v for the red wire and chassis ground for the black. test these wires the same way the amplifier is tested and repair any wires not functioning correctly. if this does not help, respond with more detailed accurate assessments of problem for further advise.
Ford Taurus Car Stereo Radio Wiring Diagram Radio Constant 12V+ Wire: Green/Yellow Radio Ignition SwitchFord Taurus Car Stereo Radio Wiring Diagram Radio Constant 12V+ Wire: Green/Yellow Radio Ignition Switched 12V+ Wire: Yellow/Black Radio Ground Wire: Black/Light Green Radio Illumination ...Dimmer Wire: Light Blue/Red Radio Antenna Trigger Wire: Orange/Blue Radio Amplifier Trigger Wire: ...ed 12V+ Wire: Yellow/Black Radio Ground Wire: Black/Light Green Radio Illumination ...Dimmer Wire: Light Blue/Red Radio Antenna Trigger Wire: Orange/Blue Radio Amplifier Trigger Wire: ...
If you are unsure of the remote wire, locate your radio fuse and get a fuse connector. hook it into the fuse and run it wherever you need it. all the remote does is swith the equipment on and off.
Unless your vehicle has a built in amplifier or your installing an aftermarket one then you can leave it off. A remote wire will turn on an audio accessory if you have one.
You can look at the in and out connectors on the TV and the amplifier. You have choices that depend on the tv and amplifier, basic stereo, surround sound and tos-link. As you know in and out are connected and out and in are connected. Do not connect in and in to each other and do not connect out and out to each other.
The wiring colors for a 1997 Cadillac Deville radio with an amplifier are easy to identify. The radio battery constant 12v+ wire is orange, the radio accessory switched 12v+ wire is yellow, the radio ground wire is black, the radio illumination wire is gray, the dimmer wire is brown, and the antenna trigger wire is pink. For the front speakers, the left front speaker wire (+) is tan, the left front speaker wire (-) is gray, the right front speaker wire (+) is light green, and the right front speaker wire (-) is dark green. For the rear speakers, the left rear speaker wire (+) is brown, the left rear speaker wire (-) is yellow, the right rear speaker wire (+) is dark blue, and the right rear speaker wire (-) is light blue.
you want to wire the batteries in series...connect negative of one battery to positive of the other. You then use the two remaining terminals as youe - and + 12v source
Yes.
The wire should rest at 12V+ or zero but when the parking brake is on the wire goes 12V- .