you take the socket and plug the flasher into it
Ground wire
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
Depends on the size of the wire in the extension cord. The 3 prong is just the hot, neutral, and ground.
3 prong the 2 black wires are your hot and the braided is your neutral.
An old 2 hole receptacle can be changed to a 3 hole receptacle that will accept a 3 prong plug, provided a ground wire is available at the box and connected to the ground (green) lug on the new receptacle. A 2 hole receptacle has a hot and neutral wire, while a 3 hole receptacle will require a ground wire connection -- in addition to the hot and neutral wires.
Ground wire
No, the wide prong is neutral it is the white wire. The narrow prong is hot it is the black wire. The round prong (in a 3 wire plug) is safety ground it is the green wire.
Black wire to the gold screw, white wire to the silver screw, green wire to the round or U shaped prong screw.
No.
Depends on the size of the wire in the extension cord. The 3 prong is just the hot, neutral, and ground.
2 prong is a hot and neutral and a 4 prong is a 3 phase with a ground wire.3 pole 4 wire meaning 3 hots could be 240 volts or 480 volts
3 prong the 2 black wires are your hot and the braided is your neutral.
An old 2 hole receptacle can be changed to a 3 hole receptacle that will accept a 3 prong plug, provided a ground wire is available at the box and connected to the ground (green) lug on the new receptacle. A 2 hole receptacle has a hot and neutral wire, while a 3 hole receptacle will require a ground wire connection -- in addition to the hot and neutral wires.
4 probably means 3 phases power source, if you do not have this source then the drill will not operate/ One wire is earth ground.
The turn signal flasher relay is located in the front seating area, on the driver's side of the car, under the dash, on the driver's side of the steering column. It is mounted on the support bracket under the dash. The flasher relay simple pulls out. It has a 3 prong connection.
You don't. A 2 prong plug has two wires, one called live (black or red wire in the US) and the other is neutral (white or gray wire in the US). A 3 prong plug needs a third wire for ground (bare copper, green, or green-yellow in the US). The only time you can replace a 2 prong plug with a 3 prong plug is if the 2 prong plug incorrectly replaced an original 3 prong plug.
Do not use this type of cable to feed a 120/240V dryer outlet. The outlet is ungrounded, and the third conductor is neutral not ground. Your ground wire must be sheathed by code. You cannot use the bare neutral conductor as ground. Diagram Did Not Come Through. You Have a 3 Prong Connector. The Prong On The Bottom By Its Self Connect The Bare Wire. That Is What Was # 3 Connect The Others To The Two Prongs Next To Each Other. Hope This Makes Some Sense (1) (2) (3) Connect White To (1), Connect Black To (2) Bare (3) Good Luck