0
Connecting a Remote Starter Switch on a 1998 Dodge Ram 1500 5.2L Engine?
Wiki User
∙ 14y ago
ok
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you trouble shoot a starter problem?
When you try to start engine is there any noise,such as clicking from area of starter?If you can hear a clicking , this usually indicates poor connections.To trouble shoot starter problem, the first thing i would do is determine if it is starter or solenoid.To do this ,you need a remote starter switch,connected to starter solenoid.Solenoid is located either on the starter,or on firewall in engine bay,depending on what vehicle you have. if you dont have a remote switch, you can short the solenoid terminals with a screw driver.When shorting, if the solenoid is good you will hear clicking.If you dont hear anything , replace the solenoid.If you hear clicking and starter doesnt work, pull the starter out and replace .
Starter makes grinding noise after engine is warm but if the remote start is used there is no noise is this due to a relay through the ignition switch?
The starter should only be making noise if you attempt to start the car and the starter is going bad. It is possible that the remote starter is bypassing the mechanical starter. Starters are very easy to replace. Be sure to disconnect the car battery before doing so.
Which model bulldog remote starter has a remote switch with only 2 buttons on it start and stop?
model rs82p/rs79p
How do you hook up a remote starter switch?
If you can get to the starter, you hook up one side of the switch to the terminal that goes to the battery and the other side of the switch to the small terminal marked with and "S". "S" is for starter. The other small terminal you leave alone. Applying power to this terminal will damage the starter.
Do you can switch on an amc 258 engine with a ford starter?
yes
Subaru check engine code 12?
It is possible that a Subaru Check Engine Code #12 is a bad starter switch. This is usually the starter relay switch malfunction code for Subaru.
How do you bypass a starter solenoid?
A starter solenoid can be bypassed by connecting a jumper wire between the battery and ignition posts on the starter. This will cause it to spin immediately without using the ignition switch.
Where is the starter relay on a 1996 Dakota?
The 1996 Dodge Dakota starter relay switch can be found on the firewall in the engine compartment. The starter relay switch will be on the drivers side of the firewall.
How do you remove the power steering bracket without taking off to heads on a 2002 escape engine?
If your vehicle has a remote starter, you must turn the ignition switch to the "on" position before you depress the brake pedal.
Why will my car start with remote starter but not with key?
There is an electrical problem between the starter switch and the starter solenoid. The most likely cause is a loose connection at the solenoid or the fusable link has melted.
What starts a car?
The ignition switch completes the circuit of electricity from the battery to the starter that actually turn the engine over and starts it.The ignition switch completes the circuit of electricity from the battery to the starter that actually turn the engine over and starts it.
Why wont your 1992 Camero Engine rotate when you attempt to start it?
bad battery or cables. Automatic trans not in park. Broken loose connections at the starter or ignition switch. Starter moter pinion jammed in flywheel. Bad starter, or ignition switch. Seized engine.
