answersLogoWhite

0


Best Answer

do a pressure test on the cooling system. the pressure will make the leak more apparent. hopefully you'll be able to pinpoint it. as a side note i had a very slow leak that was dripping of my oil pan. i had the cooling sys pressure tested and it ended up being the pulley on the waterpump.

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Coolant leak towards the rear of your engine on a 96 Chevy silverado 5 7 350 4X4 you had the manifold gasket replaced before so you know its not that Just too hard to see where it comes from?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Reprint sticker price silverado 2007?

It is towards the rear on the left side of the intake manifold


Where is the oxygen sensor 1 bank 1 on a Mitsubishi Galant?

its the 1 on the exhaust manifold pointing out towards the front of the car. i just replaced it on mine


Where is the coolant temp sensor on a e46 318i 1999 bmw?

Standing in front of the car looking at the engine the coolant temp sensor is located on the right hand side of the cylinder head at the back towards the firewall under the inlet manifold.


Where do you locate the starter for 2001 Chevy silverado 1500 8-cylinder 5.3l?

Standing in the front of the engine, It will be on the bottom left side of the engine towards the rear, Up under the exhaust manifold.


Where is the reset button for low coolant?

There isn't one; If the coolant level is ok, and the warning light still comes on, you have a defective sensor that needs to be replaced. It is located on the passenger side of the radiator with the wires running back towards the engine. Usually.


What is Small block Chevrolet coolant flow path?

Coolant enters the water pump from the lower radiator hose. The water pump pumps coolant into both sides of the engine block towards the rear of the block. Coolant then flows up into the cylinder heads and flows toward the front of the heads before crossing over into the intake manifold and up to the thermostat. Coolant then flows through the thermostat into the upper radiator hose back into the radiator.


Where is the temperature sending unit on a 2002 Pontiac grandprix?

Hi, I recently replaced the coolant temperature sensor and thermostat on my '01 GTP. Are you referring to the temp. sensor? If so it's directly below the thermostat on the top of the motor obviously towards the driver's side. take the plastic cover off of the top of the motor and follow the upper raditor house down to the neck on the top of the intake manifold. directly below that is the sensor screwed into the manifold right below the neck (where the thermostat is).


Where is the knock sensor on a infinity j30?

The knock Sensor on a J30 ( I have a 1995 ) is at the rear of the engine in the center , under the intake manifold. Find your EGR valve then it is just below that and towards the center of the engine . It is about 3" to 4" under the manifold. YOu can see it with a mirror and a bright light. I am not sure if it can be replaced with out removing the manifold , All I have read says you have to. I am going to try and do it with out all of that work.


Where is coolant temperature sending unit on a 1992 tpi 350 Z28 camaro?

I (think) as you look at the engine it's on the right head towards the front just under the exhaust manifold. You can see it more easily from under the car.


Where is the coolant temp sensor on a Chevy S-10 2.2L?

The SENSOR is located towards the fron of the engine on top of the intake manifold. The temp SENDER is located on left side of the engine block near number 1 spark plug.


Where do you add coolant?

coolant overflow tank. probably on top left side of engine towards the front.


Where is the ignition module on a 95 Silverado?

Take your distributor cap off and its right under your rotor cap towards the firewall(near the back) it has 2 screws holding it down and 3 connectors attached to it,hope this helps,just replaced mine.