My wiper blades have stopped working and the window washer isn't spraying out.
The compressor working to remove the heat from the air, but the blades could be dirty if the unit is old which throws off the balance of the blades and could cause this.
www.lawnmowerman.tv/Troubleshooting.asp The problem could be that the lawnmower is out of gas or that something has caused the blades to not turn. Check to make sure the gas tank is full and that there is nothing inhibiting the blades from turning.
i am trying to but it is not working evrrey thing they say to do it is not working
If the engine is running properly and the blades are not working there are a couple things that could be causing it. 1) The cable or linkage that operates the pulley to engage the blades is broken or bent. 2) One of the pulleys are bad. 3) The belt is broken. #3 would be the most common problem.
They are asking you to explain why you are interested in working for them, doing this job. The answer you give must be your own but you could include your ambitions to grow in post and perhaps do more.
If it's "hunting" for idle, it could either be your TPS (throttle body position sensor) has gone bad or in my case...bad fuel pump with intermitten fuel pressure.
There are quite a few different things that could cause shoulder blades to pop out of place. Car accidents could cause this.
There could be as many as 100 blades of grass in one square inch of lawn. This number could double if the grass is very lush.
The intermitten wiper relay is bad just found this on my daughters 1994 Jeep GC. If you remove the cover under your hood release cable to the left of the brake petal you will find the relay. You can pull it out and hook the wiring harresses together and wipers will work, but the intermitten will not.
The word you are looking for could be blades or reeds.
A lot depends on what year you're working with. Perhaps you could restate the question to better explain what exactly you want to do.
They could be stuck together if it's real old, or the blades aren't connected properly to the engine.