As a chain this would work, but generators and batteries are not 100% efficient, so you will lose energy at each step. Subsequent batteries and generators along the chain will become less powerful as the energy dissipates.
There are an unlimited number of ways you could make a mini generator. You could use fan power for example.
They are used together to make hydroelectricity.
Install a good generator or alternator.
It means that you have an alternator fitted. An alternator needs an amount of battery voltage to generate electricity. A generator/dynamo will make voltage without a battery being present.
It is usually a steam turbine that powers a large generator, in which case it is the mechanical force caused by high pressure steam impinging on the turbine blades.
A mitochondria is similar to a battery- they both make energy. Or you put a generator or the engine of a vehicle
You need a wind power generator to make the electric energy to hook your light to. Maybe charging a battery with the wind generator and running the light bulb off the battery will provide better service.
The first thing that I would investigate in the battery cables. Make sure they arent damaged, or loose. Make sure they are good and tight at the connections to the battery and where everythey connect to. This is the most common probably. Also check the wires at the generator. Good luck.
You can't. What you could do is build a generator that creates power. You take the magnet past a coil and a small current is generated. Doing so may times and really fast causes more power.
Most automobiles built since 1960 have an alternator (alternating current generator), driven by a belt off the crankshaft. The AC voltage is converted to DC by a solid-state diode bridge built into the unit. The current charges the battery and powers all the electrical devices in the car while the engine is running. When the engine is turned off, power comes from the battery.
it has a negative side and a positive side that powers objects
If a generator turns off or will not start up due to loss of magnetism, it is possible to use a 12 volt battery to make it work. You have to remove the exciter fields, measure the exciter field resistance, connect the F+ to the positive end of the battery, hold the F- lead near the insulated part of the lead wire and place it on the negative end of the battery for 5 to 10 seconds, then reconnect F+ and F- to the regulator.?æ