Four times as much.
Current flows through a resistor, not across it.
A: the answer lies with the power consumption of any device while operating normaly.
When an electric current flows through a resistor, the resistor resists the flow of the current, causing a decrease in the current. This decrease in current is proportional to the resistance of the resistor, as described by Ohm's Law.
Your question reveals fundamental misunderstandings about the nature of electricity.'Voltage' is simply another word for 'potential difference', and a potential difference appears across opposite ends of the resistor; it doesn't 'travel through' that resistor! Current, on the other hand, DOES 'travel through' the resistor and is caused by the potential difference across the resistor.Resistance is the ratio of potential difference to current. So if the resistance remians unchanged when the current through it doubles, then it has happened because the potential difference has doubled.
What is the current running through resistor four?1 amps..!What is the current running through resistor one? 3 amps...!What is the current running through resistor three? 2amps..!What is the current running through resistor five? 3 amps..!What is the voltage drop running through resistor five? 45 volts...!What is the equivalent resistance through the parallel portion of the circuit? 6 ohmsAnswerA resistor is a conductor, albeit one with a higher resistance than a length of wire, so current passes through it without any problem. The magnitude of the current will, of course, be somewhat lower because of the additional resistance.
Current flows in loops, voltage drops across elements. With relation to current, what flows in, must flow out, so no, current is not dropped across a resistor, it flows through a resistor and voltage is dropped across the resistor.
Current moving through a resistor causes it to heat up because of the flowing electrons bumping into the atoms in the resistor.
A ballast resistor is an electrical resistor whose resistance varies with the current passing through it, thus maintaining a constant current.
Two resistors wired in series (no mater if they have the same resistor value or not) will always have the same amount of current flowing through them. Therefore, the current flowing through the second resistor will be equal to the current flowing through the first one. The current through every component in a series circuit is the same. The voltage across every component in a parallel circuit is the same.
No. If a voltage is applied across a resistor, a current flows through it.
Connecting an ammeter in series with a resistor in a circuit will not affect the current through the resistor. The ammeter measures the current passing through it, so it becomes part of the circuit and simply measures the current flowing through the resistor without changing it.
The correct question is what is the voltage drop across a resistor or the current flowing through the resistor using Ohm's Law where Voltage = Current x Resistance