This either means that your emergency brake (hand brake) is on, the light switch needs to be fixed, OR (most common) you need to add more brake fluid. Always check your brake fluid first!
Were and how do you change a brake light switch on a Daewoo Leganza 2001
I just had my Daewoo Leganza brake light switch replaced. It goes under the brake pedal. and now my brake lights work fine.
it goes under the brake pedal, it should twist out , it has two tabs on it , only about a half turn
Auto Zone part #80171.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
Check your alternator, Mine did the exact thing. The Battery light and the !!BRAKE!! Light came on and couldn'y figure it out for the hell of me, did volt tests while running and only had 12.5 volts on the battery. I changed the alternator ($179.99) and got back to the normal 14 or so volts while running and lights shut off. no idea why the brake light was on at all.
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
Check the brake fluid level, as on many vehicles the "emergency brake" (in the UK, Hand-brake) warning light also acts as a warning light for low brake-fluid.
That warning light means a light bulb is out. Check all of your brake lights (including the brake light on the rear dash!)
Disconnect battery and leave for about 10 min. Then reconnect. The check engine light went away on mine.
How do you reset the brake pad warning light for a 2005 c320 mercedes benz?
The brake warning light comes on in your dash if the emergency brake is on or the brake fluid level in the brake master cylinder in your engine compartment is LOW