As I understand it, Bank 2 should indicate driver side, and sensor 1 should be the sensor closest to the front of the car, upstream of the catalytic converter. The safest way to find out for sure, is to find an honest Ford service technician and ask! Good luck
This is referring to the first Oxygen sensor, located on the exhaust manifold. It either indicates a short in the wiring or the sensor needs to be replaced altogether.
bad vehicle speed sensor
P0135 O2 Sensor Heater Circuit Malfunction (Bank 1 Sensor 1) Bank one is drivers side. Sensor 1 is the one closest to the engine.
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
The Mass Air Flow sensor is located on top of the air filter housing on Ford Explorer.
The 1998 Ford Explorer 5.0 liter engine IAT sensor is located between the engine and the air filter box. The IAT sensor will be on the air intake hose.
Code 340 indicates a malfunction of the cam position sensor/circuit.
It is aturbine\speed sensor malfunction. It usually means that this speed sensor has gone bad. Good luck.
The wiring map sensor tells the diagnostic program. If the problem arises and where the problem is located. The wiring map sensor is located below the dashboard.
the crankshaft sensor is located behind the crank pulley. the bottom pulley
The turbine shaft speed (TSS) sensor is located inside the automatic transmission.
Bank 2 is the drivers side of the engine in your Ford Explorer Sensor 2 is after the catalytic converter ( downstream )