Want this question answered?
disc plough are used for bringing out clods or lumps of soil and inverting them
mould is a hollowed out block that is filled with a liquid like plastic , glass, metal, ceramic raw material. while cavity is a small passage for flow of material in mould or die.
The difference in level between the height of the mould and that of the highest point of the subsided concrete is measured. This difference in height in mm. is taken as Slump of Concrete.
thallus is the entire vegetative body of mould and consists of hyphae ( mass branching,interwined filament).
An advantage of moldboard is how it effectively buries the old surface of crops. A disadvantage is that this method of plowing requires a lot of energy resources.
Mould are fungus, not living things and does not have chlorophyll.Ferns are living things and have chlorophyll.Although these two things reproduce from spores, they have a difference.
In injection moulding the polymer is moltern and 'injected' into a mould. in blow moulding the polymer is as a sheet or as a parison that is pushed into a mould by air. I guess the main difference is injection moulding fills the mould with solid parts where as blow moulding just creates a thin surface
shugfa udg rra dhyyrswj rust is made up of all mould, wee and poo
casting is that in which the metal melts in liquid form by heating and drawn in the mould. after some time it takes a shape of mould. forging is that in which the metal heated (at that point in which it is in a solid form) and took the shape by hammering, punching, pressing etc.
Prof. MasonVaugh is the father of Agricultural Engineering in India. He was an agricultural engineer at Allahabad Agricultural University. He is the first person to start research in the field of agricultural engineering and became the father of Agricultural Engineering in early forties. He established Department of Agricultural Engineering in Allahabad Agricultural University. Several implements such as Mould Board Ploughs (Wah Wah Plough, U.P. No.1, U.P. No.2, Shabash Plough) hoes, cultivators and wheat thresher were, for the first time introduced in India, by Prof. Vaugh.
injection mould blow mould extrusion mould Comprssing mould
Because of bacteria or dirt getting stuck to the food which causes mould. Write on my message board if you have any questions!