Mercury Mountaineer

Do I have to remove the driver's side door panel to replace the speaker on a 2002 Mercury Mountaineer?

123

Top Answer
User Avatar
Wiki User
Answered
2008-09-13 01:12:33
2008-09-13 01:12:33

Yes, the Speaker is in the door.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Yes, the door panel needs to come off to replace the speaker.


# Remove the door trim panel # Remove the mounting screws withdraw the speaker unplug the electrical connector and remove the speaker


Remove the speaker covers from your 1997 Mercury. Remove the door speaker retaining screws. Remove the door speaker wiring harness. Reverse the process to install your new door speakers.


How many speaker's does a Mercury Mountaineer have?


To find your speaker wires, check your owners manual. You should find a diagram with the location and color of your speaker wires.


The plastic covers usually snap onto the outer edge of the speaker. Using a small pry bar or a screwdriver around the edge should pop it off.


The speaker sizes for 97-2001 mountaineer that would make a stock fit would be a 5x7" speaker for front and rear. The Ford/Lincoln/Mercury company is notorious for using this size. You can also double check those kind of figures for any vehicle on crutchfield.com, a leading online audio/video company.


Remove the rear speaker cover from your 1999 Mercury Cougar speaker. Remove the rear speaker retaining screws. Remove the wiring harness from the back of the speaker. Reverse the process to install the new speaker.


How to change door speakers on a 1997 mercury tracer wagon


5x7 all the way around. Replace with after market 6x8 with 5x7 holes.


you will take the rear door panel off..there should be one screw and some plasic 'trees'...you will slide the arm rest/power window switch through the opening (so you dont have to unplug it) and the 5x7/6x8 speaker will be right there...you will need a smalled socket set to remove the speaker


NEED COLOR CODE FOR RADIO SPEAKER WIRE 93 MERCURY


If the short is in the speaker itself just replace the speaker.


I have a chevy 2001 ls tahoe. How do you access the drivers side door speaker to change step by step.


The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.


rear door-remove the door panel. back speaker carefully pry off grille cover and replace speaker


Open the back door up to your cargo area and on the right hand side you should see a plastic cover over a speaker- if you remove that plastic speaker cover you will notice a silver thing to the left of it stored inside that area. The silver thing is your factory amp. Hope that helps!


Hi, 3 way speaker system will have 3 drivers Low,Mid & High frequenct drivers and a 4 way will have 4 drivers Low,Low Mid,High Mid & High frequency drivers. Rgds, Brijith


How do i replace subwootfer 2002 xj8


The Speaker would replace the President if there were no vice-president.



You will get lower output and the amplifier will still work fine.


Remove door panel, remove 4 screws, remove speaker, put new speaker in, replace screws, replace door panel. Done.


it has 2 drivers, one for low and one for high frequencies, thus, 2 way speaker system


you can replace it unless you want to put the GBC together again. the original game boy's speaker is about 1.5x larger than the GBC's, it wont fit in the case.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.