0
Catback is shortened slang for "everything back from the catalytic converter". It is a bolt on exhaust which connects to the rear of the pipe holding the catalytic converter, and ends with the muffler and exhaust tip. In short, you need a cat to have a catback.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the catalytic converter on 2002 Chrysler Town and Country?
The catalytic converter in directly behind the engine. ( might need to use a flashlight ) It is bolted right to the exhaust manifold. The catalytic converter in directly behind the engine. ( might need to use a flashlight ) It is bolted right to the exhaust manifold.
Is a catalytic converter required for a 1998 dodge ram 2500 with an aftermarket exhaust?
Yes, legally and for the computer to function correctly you will need a catalytic converter.
What could cause a catalytic converter to rattle.?
Catalytic converters do not rattle. If it does it will need to be replaced as it may block the exhaust. Loose heat shield?
How do you change catalytic converter for Honda CR-V 2001?
The catalytic converter is a sealed unit and must be replaced completely. A good mechanic or a shop that specializes in exhaust systems can do the job. If the entire exhaust pipe doesn't need replacing, the converter itself can be cut out of the existing exhaust pipe and a new one fitted in.
Wont pass smog not burning gas to much crude gasoline is coming out at the exhaust?
You need a catalytic converter
Is it legal to remove the catalytic converter from a diesel pickup in Michigan manufactured before 2007?
u need to check your exhaust system i have never yet seen any diesel that has a catalytic converter installed
How do you remove a catalytic converter from a 1989 Ford Thunderbird?
First make sure the car is cool. Then you will need to get under your Thunderbird and remove the clamps that hold the catalytic converter in place between two lengths of exhaust pipe. You will then be able to remove the converter.
How do you fix code P0420 on a Chrysler Town and Country?
If there are no exhaust leaks or other codes, the catalytic converter has failed. You will need to replace it.
What is the difference between high flow catalytic converter and regular converter?
There are no differences. High flow catalytic converters are not really high flow; the catalytic converters you have on your vehicle are as high flow as you need them to be. A "high" flow converter will either be of a larger diameter, or the inside is made in such a way that there is less restriction to exhaust flow.
How do you change a Volvo 240 catalytic converter?
Working on the exhaust system is a job best left to a professional. You will save very little by doing it yourself. Have the catalytic converter tested to be sure you need a new one. Catalytic Converters are very expensive so you do not want to replace a good one. If it is bad you need to find out why it went bad. Things like a miss on a cylinder from a bad plug or a defective O2 sensor will ruin the converter. Also a burnt exhaust valve will destroy the converter.
Looking for a diagram of the catalytic converter - exhaust system on a 1988 f250 the exhaust was customized to have two pipes going into one catalytic converter do you need two for emissions?
Actually it probably wasn't customised. That is how they were made. The two sides go together right at the cat converter. There is a four bolt flange at the interface between the crossover pipes and the cat.
How do you change the front catalytic converter on a 2002 Mitsubishi Eclipse 2.4L?
The catalytic converter is usually held in place by a set of clamps located at the front and rear of the unit. These clamps tie the unit to the exhaust system. If your converter is welded to the exhaust pipes, you will need to remove the old welding and weld the new one in place, or bring it to a service station and have them do it.
