Want this question answered?
Typically, you just disconnect it, unbolt any retaining bolts, and pull it out. Always disconnect the negative cable first when removing a battery and reconnect the negative cable last when installing a battery. The pertains to a negative ground system only.
Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.
Always disconnect the negative battery cable first even if you are changing the positive cable and reconnect the negative cable last. This is to prevent accidental shorts to ground.
Disconnect the negative cable from the battery. Now disconnect the other end from its ground point. Take that cable to you local auto parts store and buy a replacement. Reverse the procedure to install it.
Mostly so you don't burn your hand. One should also disconnect the negative ( ground ) battery cable before removing any electronic parts.
You have to disconnect the ground wire from the block. You have to disconnect the positive wire from the starter and the alternator and the powerline going to the fuse box. and connect the new ground then the positive
Disconnect the negative battery cable.
Yes, you better disconnect the negative battery cable.
Remove the ground or negative cable first when disconnecting your car battery.
To remove the battery from a Celebrity: !. Disconnect the ground cable from the battery. Use gloves to keep battery acid off of your skin. 2. Disconnect the positive cable. 3. Unbolt the brace that is over the battery and move it out of the way. 4. Remove the battery hold down at the base of the battery. 5. You should now be able to lift the battery out of the battery box.
Disconnect the cable from the LeSabre battery. Follow the route of the cable and disconnect the other end. Pull the cable out, then fit the new cable in the same direction. Connect the non battery end, then connect to the battery.
Disconnect and remove existing cables Replace with new cable using the routing used by original cables + from battery to starter solenoid - From battery to good engine ground