Always disconnect the negative battery cable first even if you are changing the positive cable and reconnect the negative cable last. This is to prevent accidental shorts to ground.
To change the positive battery cable on a 1988 Jeep Cherokee trace the end of the cable to the starter. Unplug the battery then remove the cable from the starter. Measure the old positive cable with the new and be sure to replace the unit at the right size.
1. Remove negative battery cable 2. remove positive battery cable 3. remove battery 4. install new battery 5.attach positive cable 6.attach negative cable
Remove the old battery, disconnect the negative cable first and install the new battery connect the negative cable last.
Replace the battery cable with an OEM style cable. Do not use a clamp on terminal.
the whole cable or just the cable ends ??????????????
Remove brackets that hold existing battery in place. Unscrew negative cable, then positive cable. Pull old battery out. Place new battery in. Fasten negative battery cable, then positive one. Place bracket back on and tighten nuts.
disconnect negative side first.... then disconnnect all connections to the pos cable labelling as you go... replace with new cable... reconnect to battery.
Disconnect the cables at the 1997 Nissan battery. After following one cable to the other end, disconnect it then pull it out. Feed the new cable in the same way. Connect the non battery end. Do the same for the other cable then connect the cables to the battery.
The battery should have one bar that holds in in place unscrew the nuts that hold the battery down , take your negative battery cable off, next take your positive battery cable off take battery out put the new battery in put the negative cable back on then your positive cable back on put your hold down bar back on tighten your nuts. that's it
take the negative batter cable off, then the positive cable off, undo batter hold down clamp, take battery out. put new battery in, install batter hold down, install positive cable, then install negative cable. (in that order)
Unhook the Caravan cables at the battery. one at a time, follow the cable to the other end, paying attention to the routing. Disconnect the other end, pull the cable out, then route the new cable the same way. Connect the end away from the battery. Repeat for the other cable, then hook back up to the battery.
Remove the Neg. Cable first, then the + Red cable. Slide up the insulation cover around the battery. Unscrew the battery holding plate on the bottom near the engine. Pull out battery. Drink a beer.