No. just remove the calipers
how do you change out the distributor assembly on a 1989 ford f250
On my 1989 f250 the oxygen sensor is in the exhaust header pipe a few inches in front of the catalytic convertor
have you tried the proportioning valve. sometimes dirt will get in there and clog the returns.
i have to change oil pump f250 351winsar.how topull the engine out?
1989 ford F250 Fuel Problems, It cranks but wont start
Yes you can
how to install a serpentine belt on 1989 f250 diesel 7.3l
Replacing a ball joint on a Ford 250 requires removing the wheels, brake assembly, as well as the spindle. From there, the ball joints can be removed and replaced.
16 in
how do you change the oil filter on 2006 f250 diesel?
Lift the vehicle with a jack, remove the tire, remove the caliper/brake shoe, remove the old brake pad. Dispose of the old brake pad properly, put in the new brake pad, replace the caliper/brake shoe and replace the tire, then lower the vehicle to the ground.
replace brake light switch located on brake pedal under dash