Do you have a problem your well Water Pump Pressure Control Switch is making a lot of noise and you have a lot of air in your water lines?
You need to switch off the pump, drain the pressure tank and fit
a new pressure switch. They are cheap and often last only a few
years. When re fitting make sure the pressure tank residual
pressure is about 2 PSI LESS than the pressure switch ON setting.
In most domestic wells systems the pressure switch comes ON at 30
PSI, so the tank air should be 28 or so.. Also check all joints and
fittings, there is an air leak somewhere.
You need to switch off the pump, drain the pressure tank and fit a new pressure switch. They are cheap and often last only a few years. When re fitting make sure the pressure tank residual pressure is about 2 PSI LESS than the pressure switch ON setting. In most domestic wells systems the pressure switch comes ON at 30 PSI, so the tank air should be 28 or so..
Your blinker lights on your 1996 Nissan XE truck will not work but your hazzards do whats the problem?
The simple explanation is the best one. A switch is a device that is designed and engineered to interrupt or break a circuit. When the switch is closed, things are powered up. Open the switch and it stops electron flow by opening the path current was using. It's by either "making" or "breaking" the circuit that the switch controls it.
Why am I bleeding with blood clots every other week if I take birth control continuously to control my ovarian cysts?
What if your 1999 Aucra TL turns off while driving you can restart it and it runs fine Any ideas what could be making it do this It has 180000 miles no major repairs have been done and it drives great?
What could be the problem if a Teledyne-Laars pool heater's pilot light was lit with no problem the valve is 'ON' but the burner does not start up?
The database did not find the text of a page that it should have found, named "What could be the problem if a Teledyne-Laars pool heater's pilot light was lit with no problem the valve is 'ON' but the burner does not start up". This is usually caused by following an outdated diff or history link to a page that has been deleted. If this is not the case, you may have found a bug…
I've been trying to figure this out also. I think I've found a solution for the brake light signal. Roadmaster Inc makes a mounting bracket and wiring kit #751426. The kit is made for making an Uplander towable behind a motorhome, but should be ok to wire into a brake controller. The reason this switch is needed is because the factory switch on the brake pedal isn't an On/Off switch. It's a variable resistance switch…
You just had an ignition switch replaced in 2004 Saturn Ion and it's not starting again when it's really cold can you replace the switch myself and where is the switch and how do you do it?
This is an on-going problem with Saturn ignitions.....The switch apprently has some internal grease that prevents the switch from making contact and starting the car (especially when it is cold).....You can replace the switch, but I have a better idea.....Spend the money you would have spent on a new switch by installing a remote starter.....should cost you about $300.00 installed.
Where is the radiator fan switch on a 1998 Mystique My fan won't shut off even after cool down. Is it the fan switch or something else?
I am fighting the exact opposite problem on a 96 Mystique. I cant get my fan to come on and i have traced it back to be a ground problem. Wherever the switch is, it turns the fan on and off by closing the ground side of circuit, and activating the relay. Start by checking your relay, and making sure its not stuck "OPEN" otherwise, the switch, (Where ever it may be) is bad.
Why will the headlights and high beams on a 1986 F150 not go on even though the other lights activated by the light switch do?
I had the same problem on my 87 f-150. You will have to take the dash apart and remove the whole switch assembly. The problem is the retainer on the switch is melted from the heat generated and the wires aren't making contact in the module. I was unable to find an aftermarket replacement but you may find one at a salvage yard. Good luck.
To produce sound from the violin, you place the bow and move it back and forth across one string. To change the note played on the violin, you place your fingers on different parts of the string. To control the volume, you can put more pressure on the bow making the sound louder, or putting less pressure to soften the volume.
Ford f350 cant start with key but you can crank it with key on from the starter selenoidput on new solenoid and battery did not find any bad fusesany help?
buy a new starter switch. WAIT! I had the same exact problem and replaced the solenoid with the same result. It is actually the neutral switch not making contact when you are engaging the clutch. Try pressing the clutch down really hard and it may start. Or better yet, just adjust the contact switch towards the clutch and you have fixed the problem! Unless the starter switch is the same thing the mechanic that told…
What do you do if your brake lights only work when you pull back on your high beems in a buick reagal and how can it be fixed andor what is making this happen?
I have the same problem- press on the brake, no brake lights. Press on the brake and pull back on turn signal/high beams lever, brake lights turn on! Jiggle the lever, brake lights turn on, but left turn signal does not work. I have replaced the switch that is down near the brake pedal and that is not the problem. I think you may need to replace the whole turn signal/high beams/cruise control switch....or at…
Your 2001 Pontiac Grand-Am is making a clicking like the turn signal is on while you're driving but the signal is not flashing or on whats the problem?
I just had this problem with my 2002 Pontiac Grand Am. The problem is a short in the "multi-function switch." When I took it to get fixed, they told me that a lot of Pontiac Grand Ams have had this problem, and mine was fixed through warranty. If that is not the problem with your car, check the "signal flasher relay." Hope I helped!
1989 Mercedes Benz the oil pressure is up when the engine is cold when you put your feet on the gas it go back up but while you are waiting for the light to change it drop to near zero?
The chances are good that it is the oil pressure switch. As long as it goes up when you hit the gas, and as long as the engine isn't making any noise (excessive ticking or rapping) then you don't need to worry about it. Change the pressure switch only if it annoys you, oherwise, just get use to it. There is also an "idiot light" for the oil pressure, so if you really loose the…
89 Honda CRX si notice when trying to start check engine light wont shut off making motor not start and if it goes off it will start and run fine and then light will come on and kill the motor?
Your horn does not work on your calibra you have changed the horn and replaced the fuse black box and still no joy Can anyone help?
How do you determine which part is bad on a 92 Chrysler LeBaron when all 4 power windows quit working but fuses are OK?
you have a bad ground. probably wore threw in the door jamb. also check driver's switch. There is a main power wire that goes into the driver's switch (usually it is red }This is the main power to turn on all switches.Check wire to make sure it is making contact with switch ,also check wire that there are no cracks in the wire.Check switch itself for any black or burnt spots .It sounds like to…
Not necessarily. Most bladder tanks will work up to 80 PSI and most homes on well systems don't go higher than 60 PSI. If your bladder tank, pump and pressure switch are all in good shape then you can raise the pressure easily by adjusting the pressure switch and pumping more air into the tank. tank should have 28 or 38 psi residual air - pressure switch 'on' should be 2 PSI higher than tank…
The ignition switch is probably bad. One of the contacts is not making contact in the run position. The other possibility is a wiring problem to or from the ignition switch. It is almost always at a connection with electrical problems in vehicles. The wires themselves remain intact unless something rubs through the harnesses. If the switch is not the problem, you will need a good wiring diagram to trace connectors and wires to locate…
First, you need to fix what's wrong and making it come on. If you've cleared the problem, disconnect the negative (-) post of the battery. Turn the headlight switch on, then off, then after about 15 minutes, re-connect the battery. If the problem has not been fixed, the light will come back on. If the problem WAS fixed, it will not... until something else needs attention.
What are possible causes for the parking brake light coming on and off sporadically on a 1994 t100 Where is the switch could it be sticking?
Someone else had informed me that this light also comes on if the brake fluid is low. I added fluid to my '97 T-100 and it solved the problem. I have a 97 T-100 with the same problem. While I can't tell you for certain what is causing the problem, I suspect the switch also, and will be replacing it soon. The switch is located under the dash near the firewall, where the tip of…