Always best to bleed both sides if you change a brake line. EG: Both front or both rear.
No, as long as your pedal seemed good before the brake job, and you do not loosen the bleeder at all, you do not have to bleed the brakes.
Does this Blazer have four wheel disc Brakes? NEW ANSWER: There's no reason to bleed brakes if you did not open the system.( where brake fluid came out )
i replace my rear brake shoes on 2001 dodge grand caravan and my emergency brake is still not working
You need to bleed the entire brake system. Bleed in this sequence, RR, LR, RF, LF. If you do not know how to do this, do a search online for "bleeding brakes" THE REAR WHEEL CYLINDERS MAY BE LEAKING SHOULD ALWAYS CHANGE WHEN DOING BRAKES AND BLEED REAR BRAKES
Yes, bleeding the brakes removes air bubbles that might be left in the system, especially in the brake lines!If not done every time the brake system is worked on the brakes will be unreliable and unsafe!
If you replace any brake component that breaks the brake fluid seal or you let it get very low of brake fluid, yes, you must bleed the brakes.
you dont you bleed and adjust the brakes
No, you do not. If you change the caliper, you will have to bleed that brake line. Have someone press on the brake pedal. Open the bleed valve, while they continue to hold the pedal. Close the valve. Repeat 3 times. We did it 4 times, but 3 should do it. Works great!
To bleed brakes on your 2008 Uplander front and rear, disconnect the brake line at the caliper.
why after changing my front brakes on my Nissan altima,my brakes peddle got really soft YOU FORGOT TO BLEED YOUR BREAK LINES~! GO TO AUTOZONE, OR PEPBOYS OR ADVANCED AUTOPARTS AND GET A BRAKE BLEEDER KIT..THEY ARENT EXPENSIVE AND ALLOW YOU TO BLEED YOUR BRAKE SYSTEM ON YOUR OWN.
the symptoms are that oil will not go throw the brake lines to bleed them and the pedal some of the symptoms are hard pedal you wont be able to bleed your back brakes no oil no back brakes check these first before you change your master cylinder or your brake booster..
normally you shouldn't have to,unless you've disturbed the hydraulic side of them