answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Do you have to drain out the freon to change a pressure switch on my 2001 Chevy 3500 truck ac?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will oil pressure switch drain oil?

The Oil Pressure switch if broken off will drain "pump" the oil out of the engine very quickly.


Do you have to drain the oil to replace oil pressure switch on 2000 Chrysler 300m?

No


Do you drain radiator to change thermostat on 2003 Chevy s10?

You need only to drain off a couple quarts of coolant to change the thermostat.


How do you change the coolant on a Chevy Avalanche?

how to drain anti freeze on avalanche


Why does the dome light override switch on a 1999 Chevy Suburban drain the battery?

Either the switch was left in the wrong position, or the thing is defective. The dome lights draw enough current to drain the battery overnight.


Do you need to drain oil to change oil sending unit in 2000 chevy cavalier?

No you do not.


How you change transmission fluid chevy Malibu 2005?

To change the transmission fluid on your Chevy Malibu 2005, first, pull off the pan, drain the fluid, and replace it.


Do you have to empty your air conditioning system to change your clutch cycling switch?

Yes you do, do not remove the switch with freeon in the system. must drain system down. It depends on the vehicle. Many (if not most) of the "clutch cycling" switches are actually simple pressure sensors and there is a schrader valve which will hold the pressure while you change the valve. A little more research is appropriate for YOUR vehicle before you decide what to do.


How do you replace water well psi pressure gauge?

You switch off the pump, drain the pressure tank, then remove old gauge and fit new one.


Where is the ac high pressure switch located on a 1995 Chevy 1500 truck?

the high pressure switch is located on the back ,top of the compresssure and has a clip with two wires to it.to replace it you will have to drain the system.to install the switch you will need a snap ring tool .evacuate the system and recharge.the switch is around $21.00 AT AUTO ZONE.FIRST TO SEE IF IT IS BAD ,USE A PAPER CLIP OR WIRE TO JUMP THE LEAD SO U WANT WASTE MONEY..GOOD LUCK..


Do you have a problem your well Water Pump Pressure Control Switch is making a lot of noise and you have a lot of air in your water lines?

You need to switch off the pump, drain the pressure tank and fit a new pressure switch. They are cheap and often last only a few years. When re fitting make sure the pressure tank residual pressure is about 2 PSI LESS than the pressure switch ON setting. In most domestic wells systems the pressure switch comes ON at 30 PSI, so the tank air should be 28 or so..


How do you change the oil in your 2000 Chevy S-10 Blazer?

drain oil,change filter,refill- or go to speedy lube