answersLogoWhite

0


Best Answer

You don't have to, but without draining the radiator, you will have coolant all over the engine when you replace the thermostat. This is a good time to install a fresh 50/50 mix of antifreeze & distilled water. Don't forget to bleed all air from system.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Do you have to drain the coolant before changing the thermostat on a 2000 dodge ram pickup?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the coolant temperature sensor located on a 1995 Nissan pickup?

below the raditor hose that's connected to the thermostat.


Why does your Chevy pickup over heat?

Low coolant, bad thermostat, clogged radiator, bad waterpump, bad headgasket, etc


How do you fix 1989 S10 Chevy pickup that you have to pour gas in to start?

replace the coolant sensor, the one next to the thermostat housing.


Why would my 1994 two wheel drive Toyota pickup over heat if there are no visible leaks in the radiator or hoses?

it could be a bad thermostat or lack of water/coolant in the engine itself. Coolant will boil itself away if it was not mixed right. If the thermostat is sticking or not working, it wont let coolant that is in the block move past the radiator to cool, allowing the temperature of the block to increase and over heat Thermostat not opening?


Where do you put coolant in 1994 Chevy s10 pickup?

where do i put coolant in for 1994 Chevy s10 pickup


Why would there be no heat in 1985 Nissan Pickup before and after replacing thermostat?

you might need a heater core


Do you have a diagram for a 1979 ford pickup thermostat installation?

Located at the engine end of the upper radiator hose. Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Replace thermostat and gasket Re-fill coolant slowly to prevent an air lock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level


How do you change the thermostat on a 89 Chevy pickup 1500?

Should be located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator Remove this housing Note how thermostat is installed Clean both surfaces Install new thermostat and gasket Re-fill coolant slowly to prevent an airlock Start engine and look for leaks Run engine to normal operating temperature with heater on Re-check coolant level


Where is the coolant temperature sensor on a 94 f150 pickup?

assuming it is a 5.0 L it is located on front side of motor just left of thermostat housing however it can also be found in the back of engine located in the supply line to heater core more than likely beside thermostat


How do you replace thermostat on your ford ram pickup 1990?

ford doesnt have a ram pickup ram is dodge


What side of thermostat is up on a 1989 Chevy pickup?

There is a spring in the thermostat, And the spring goes down into the intake.


Do you have a diagram of the thermostat location 96 Nissan pickup?

A diagram of the thermostat location on a 96 Nissan pickup can be gotten from the Nissan dealership. It can also be purchased from most auto parts stores.